ผลการค้นหา

close around* *close around *close around*

ค้นเจอ 12 รายการ

around

ล้อมรอบ, รอบๆ, ล้อม, อีกด้านหนึ่งของ (มุมถนน)

close circuit

วงจรไฟฟ้าที่ทำให้กระแสไฟฟ้าเดินถึงกันโดยสมบูรณ์ ตรงข้ามกัน open circuit

close string

แม่บันได ชนิดเจาะให้ลูกนอนฝังในเนื้อไม้แน่นแม่บันได

close fitting angle rige

ครอบสันหลังคา

Banding Tool

(english) Tool used to tighten a steel band around a coil.

Bander

(english) Machine located at each delivery reel to automatically place circumference bands around completed coils.

Bedding

(english) Sinking a pattern down into the sand to the desired position and ramming the sand around it.

Bright Drawing

(english) The process of drawing hot rolled steel through a die to impart close dimensional tolerances, a bright scale free surface and improved mechanical properties. The product is termed bright steel.

Consolidation

(Concrete Engineering) Compaction usually accomplished by vibration of newly placed concrete to minimum practical volume, to mold it within form shapes and around embedded parts and reinforcement, and to eliminate voids other than entrained air.

Box Annealing

(english) Annealing a metal or alloy in a sealed container under conditions that minimize oxidation. In box annealing a ferrous alloy, the charge is usually heated slowly to a temperature below the transformation range, but sometimes above or within it, and is then cooled slowly; this process is also called close annealing or pot annealing.

Ball Piston Pumps

(english) The Ball Piston Pump is a very simple pump design. It has a rotor which revolves around an internal stator. The rotor has twelve cylinders machined out of it, and each cylinder has a ball inside which can slide in and out of the cylinder.

Bend Test

(english) Various tests which is used to ascertain the toughness and ductility of a metal product, in which the material is bent around its axis and/ or around an outside radius. A complete test might specify such a bend to be both with and against the direction of grain. For testing, samples should be edge filed to remove burrs and any edgewise cracks resulting from slitting or shearing. If a vice is to be employed, then you must line the jaws with some soft metal, to permit a flow of the metal in the piece being tested.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด