ค้นหา put up with hunger ใน คำศัพท์ช่างภาษาอังกฤษ

ผลการค้นหา

ค้นเจอ 154 รายการ

Bonderizing

(english) The coating of steel with a film composed largely of zinc phosphate in order to develop a better bonding surface for paint or lacquer.

AB Srews

(english) Sheet metal screws with pointed ends similar to type-A screws and thread dimensions similar to type-B. Type AB screws are seldom used in stainless.

Ball Burnishing

(english) A method of obtaining a high luster on small parts by rotating them in a wooden-lined barrel with water, burnishing soap, and stainless steel shot.

Acid Steel

(english) Steel melted in a furnace with an acid bottom and lining and under a slag containing an excess of an acid substance such as silica.

Work flow

(Software Engineering) the sequence of tasks that are required to accomplish some activity or action; often (but not always) used in conjunction with software process models

Acid

(english) 1) A solution or liquid with a pH less than 7, 2) term applied to slags, refractors, and minerals containing a high percentage of silica.

Toxicity

(Environmental Engineering) A U.S. EPA hazardous waste characteristic defined with a rigorous test procedure, the TCLP (for Toxicity Characteristic Leaching Procedure). In the procedure, a waste is extracted for 24 hours with an acetic acid solution. The acid extract is then analyzed for the presence of any of the contaminants listed in the procedure.

Bending Angle

(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.

Bust Coil

(english) Coils removed from the off-gauge reel. The BUST (build up side trimmer) coil contains defects (gauge variation and quality defects) and off-spec widths.

Amino acid

(Environmental Engineering) A functional group which consists of a carbon with a carboxylic acid, "-COOH" and an amine, "-NH2." These compounds are the building blocks for proteins.

Bearing Load

(english) A compressive load supported by a member, usually a tube or collar, along a line where contact is made with a pin, rivet, axle, or shaft.

A Sheet Metal Screw

(english) Sheet metal screws with (a) sharp-pointed ends; and (b) fewer threads per inch than type AB screws; and (c) deeper threads with bettere gripping power than type AB. The industrial Fasteners Institue incorrectly labes type A an “obsolete” thread though it is universally preferred in 18-8 stainless over type AB, especially by the marine industry.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด