ผลการค้นหา

ค้นเจอ 106 รายการ

Busheling

(english) A widely traded form of steel scrap consisting of sheet clips and stampings from metal production. Bushel baskets were used to collect the material through World War II, giving rise to the term.

Bending Angle

(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.

Bake Hardenable Steel

(english) A cold-rolled, low-carbon sheet steel used for automotive body panel applications. Because of the steel’s special processing, it has good stamping and strength characteristics and after paint is baked on, improved dent resistance.

Bars

(english) A relatively long straight, rigid piece pf metal; long steel products rolled from billets into such shapes as squares,rectangles, rounds,angles,channels,hexagons,and tees. In steel, “merchant bars” include rounds,flats,angles,squares,and channels that are used by fabricators to manufacture a wide variety of products such as furniture,stair railings and farm equipment. Concrete reinforcing bar (rebar) is used to strengthen concrete in highways,bridges and buildings.

Bottle Top Mold

(english) Ingot mold, with the top constricted; used in the manufacture of capped steel, the metal in the constriction being covered with a cap fitting into the bottle-neck, which stops rimming action by trapping escaping gases.

Butcher Saw Steel

(english) A hardened, tempered, and polished high carbon spring steel strip material (carbon content is generally higher than that of a material used for wood band saw applications) with a Rockwell value of roughly C47/49.

Slump Cone

(Concrete Engineering) A metal mold in the form of a truncated cone with a top diameter of 4”, a bottom diameter of 8”, and a height of 12”, used to fabricate the specimen for a slump test.

Back-up Roll

(english) 1) Roll used as a support roll mainly for plater rolls. 2) Two rolls, one on top and one on bottom of the two work rolls which apply pressure and reduce the flexing of the work rolls.

Inelastic:

(english) Not surprisingly, the opposite of elastic. A deformation of a structure or material under load is described as inelastic when the deformation remains after the load is removed. The term plastic is often used with the same meaning.

Boron Steels

(english) The addition of boron in the range 0.0005-0.005% to certain steels increases the hardenability. A range of boron steels is now listed in the current BS 970 and are widely used for the production of cold headed fastenings.

Chlorofluorocarbons

(Environmental Engineering) Synthetic organic compounds used for refrigerants, aerosol propellants (prohibited in the U.S.), and blowing agents in plastic foams. CFCs migrate to the upper atmosphere destroying ozone and increasing global warming. Typical atmospheric residence times are 50 to 200 years.

Ottawa Sand

(Concrete Engineering) A sand used as a standard in testing hydraulic cements by means of mortar test specimens. Sand is produced by processing silica rock particles obtained by hydraulic mining of the orthoquartzite situated in open-pit deposits near Ottawa, Illinois; naturally rounded grains of nearly pure quartz.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด