ค้นหา "by the year" ใน คำศัพท์ช่างภาษาอังกฤษ

ผลการค้นหา

ค้นเจอ 616 รายการ

Back End

(english) 1) Usually refers to the entry end of process lines. 2) The outside lap 2) of the produced coil, or the inside lap of the consumed coil.

Gravity:

(english) An attractive force between two objects; each object accelerates at a rate equal to the attractive force divided by the object's mass. Objects near the surface of the earth tend to accelerate toward the earth's center at a rate of ; this value is often called the gravitational constant and denoted as g.

Temper

(Concrete Engineering) The addition of water to the cement mix whether at the batch plant, during transit or at the jobsite to achieve the specified water to cement ratio.

Climatology

(Environmental Engineering) The study of the climate, how the earth's atmosphere performs over long periods of time.

Base

(english) The steel or concrete pedestal on which the coils are stacked during the batch annealing process.

Bessemer Process

(english) A process for making steel by blowing air through molten pig iron contained in a refractory lined vessel so that the impurities are thus removed by oxidation.

Inertial Force:

(english) A fictitious force used for convenience in visualizing the effects of forces on bodies in motion. For an accelerating body, the inertial force is considered as a body force whose resultant acts at the object's center of gravity in a direction opposite the acceleration. The magnitude of the force is the mass of the object times the magnitude of the acceleration.

Chair(s)

(Concrete Engineering) In concrete formwork, the support for the reinforcing steel.

Broaching 2

(english) Multiple shaving, accomplished by pushing a tool with stepped cutting edges along the piece, particularly through holes.

Saltwater intrusion

(Environmental Engineering) The gradual replacement of freshwater by saltwater in coastal areas where excessive pumping of groundwater occurs.

Burr

(english) The very subtle ridge on the edge of strip steel left by cutting operations such as slitting, trimming, shearing, or blanking. For example, as a steel processor trims the sides of the sheet steel parallel or cuts a sheet of steel into strips, its edges will bend with the direction of the cut.

Base Metal

(english) (1) The metal present in the largest proportion in an alloy; (2) the metal to be brazed, cut or welded; (3) after welding the part of the metal that was not melted during the process.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด