ผลการค้นหา

ค้นเจอ 601 รายการ

Rotation:

(english) Motion of an object where the path of every point is a circle or circular arc. A rotation is defined by a point and vector which determine the axis of rotation. The direction of the vector is the direction of the axis and the magnitude of the vector is the angle of rotation.

Chair(s)

(Concrete Engineering) In concrete formwork, the support for the reinforcing steel.

Blue Annealing

(english) Heating hot rolled ferrous sheet in an open furnace to a temperature within the transformation range and then cooling in air, in order to soften the metal. The formation of a bluish oxide on the surface is incidental.

Base Metal

(english) (1) The metal present in the largest proportion in an alloy; (2) the metal to be brazed, cut or welded; (3) after welding the part of the metal that was not melted during the process.

Scheduling

(Software Engineering) the activity that lays out a timeline for work to be conducted on a project

System engineering

(Software Engineering) focuses on the analysis and design of all elements of a complete product, service, or technology for the transformation of information or control

Transmissibility:

(english) The principle stating that a force has the same external effect on an object regardless of where it acts along its line of action.

Paradigms

(Software Engineering) the process model

Z-Mill

(english) The full name for z-mill is Sendzimir mill. A Z-mill operates with a very small diameter work roll, normally about 2 inches, backed up by a number of rolls in a pyramid-shaped stack. This roll set up allows you to exert extremely high forces through the work roll and yet keep the work roll from extreme flexing. The take-up roll on the Z-Mill also exerts a tension on the coil as it comes through the mill. The combination of high pressure and tension makes the mill capable of rolling material thin and flat.

Tests on Completion

การทดสอบเมื่อเสร็จงาน

Burr

(english) The very subtle ridge on the edge of strip steel left by cutting operations such as slitting, trimming, shearing, or blanking. For example, as a steel processor trims the sides of the sheet steel parallel or cuts a sheet of steel into strips, its edges will bend with the direction of the cut.

Bedding

(english) Sinking a pattern down into the sand to the desired position and ramming the sand around it.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด