ค้นหา "make eyes at" ใน คำศัพท์ช่างภาษาอังกฤษ

ผลการค้นหา

ค้นเจอ 93 รายการ

Stress:

(english) The intensity of internal force acting at a point in an object. Stress is measured in units of force per area. See shear stress and normal stress.

Baked Strength

(english) Compressive, shear, tensile or transverse strength of a mold sand mixture when baked at a temperature above 231 B0F (111 B0C) and then cooled to room temperature.

BURST PRESSURE

(english) The level of pressure at which a component, pipe, tube, hose or other fluid passage will burst during application of internal pressure. Normally 2.5 - 4.0 times working pressure.

Bath Annealing

(english) Is immersion is a liquid bath (such as molten lead or fused salts) held at an assigned temperature-when a lead bath is used, the process is known as lead annealing.

Block Off

(english) 1) Wooden separators which are used at both the bottom of a lift and between IPM's (bundles) of a lift. 2) The act of placing 4x4s between the lifts in the piler's box.

Pin connection:

(english) In two dimensions, a pin connection restrains two translation degrees of freedom but does not restrain rotation. Since the rotation degree of freedom is unrestrained at a pin connection, it transfers no moment.

Blast Cleaning (blasting)

(english) A process for cleaning or finishing metal objects by use of an air jet or centrifugal wheel that propels abrasive particles (grit, sand, or shot) against the surfaces of the workpiece at high velocity.

Structural model:

(english) An idealization for analysis purposes of a real or conceived structure. A structural model includes boundaries limiting the scope of the analysis. Supports occur at these boundaries, representing things which hold the structure in place.

Cement, Portland (ASTM C150) (Concrete Engineering)

A powdery substance made by burning, at a high temperature, a mixture of clay and limestone producing lumps called “clinkers” which are ground into a fine powder consisting of hydraulic calcium silicates. For non-portland cements, see aluminous cement.

Corrosive waste

(Environmental Engineering) A waste that is outside the pH range of 2 to 12.5 or a waste that corrodes steel at a rate greater than 6.35 mm (0.25 in) per year. One of EPA's four hazardous waste properties.

Bearing Strength

(english) The maximum bearing load at failure divided by the effective bearing area. In a pinned or riveted joint, the iffective area is calculated as the product of the diameter of the hole and the thickness of the bearing member.

Blast Furnace Slag

(Concrete Engineering) A non-metallic waste product developed in the manufacture of pig iron, consisting basically of a mixture of lime, silica and alumina, the same oxides that make up portland cement, but not in the same proportions or forms. It is used both in the manufacture of portland blast furnace slag cement and as an aggregate for lightweight concrete.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด