ตัวกรองผลการค้นหา
คลิกที่แต่ละคำเพื่อดูรายละเอียด
เหล็กหัวแร้งบัดกรีที่สามารถทนทานต่อความร้อน โดยไม่มีการหลอมละลาย
เหล็กตีดัด (ความหมายอย่างเดียวกับ wrought iron)
ไม้ฉากที่ทำด้วยเหล็กเฉพาะด้าม
แร่เหล็กชนิดหนึ่ง เป็นแม่เหล็กธรรมชาติ (FeSO4) เป็นแร่เหล็กที่ดูดเข็มทิศ
(english) 1) A furnace in which solid fuel (limestone, coke, iron ore) is combined with high-pressure, hot air blast (120,000 psi) to smelt ore in a continuous process (They are never stopped. They can be slowed down or idled). A Blast Furnace in the iron and steel industry is used to produce liquid iron.
(english) "Fine particles of limestone (flux) and iron ore are difficult to handle and transport because of dusting and decomposition, so the powdery material usually is processed into larger pieces. The raw material's properties determine the technique that is used by mills. 1) SINTER Baked particles that stick together in roughly one-inch chunks. Normally used for iron ore dust collected from the blast furnaces. 2) PELLETS Iron ore or limestone particles are rolled into little balls in a balling drum and hardened by heat. 3) BRIQUETTES Small lumps are formed by pressing material together. Hot Iron Briquetting (HBI) is a concentrated iron ore substitute for scrap for use in electric furnaces.
(english) A vertical shaft type smelting furnace in which an air blast is used, usually hot, for producing pih iron. The furnace is continuous in operation using iron ore, coke, and limestone as raw materials which are charged at the top while the molten iron and slag are collected at the bottom and are tapped out at intervals.
(english) The only commercial ore of aluminum, corresponding essentially to the formula Al2O3xH2O.
(Concrete Engineering) An aggregate used in heavy weight concrete, consisting primarily of ferrous metaferrite (Fe304). A black magnetic iron ore with a specific gravity of approximately 5.2 and a Mohs hardness of about 6.
(english) By-product gas created by the iron making process which is used as fuel for the boilers.
(english) A set of bolts or screws that ore selected to suit a particular application, i.e. pre-selected length, threads and strength to match the mounted component.
(english) A semi-finished hot rolled product, rectangular in cross section, produced on a blooming mill. For iron and steel, the width is not more than twice the thickness, and the cross-sectional area is usually not less than 36 sq. in. Iron and steel blooms are sometimes made by forging.