ผลการค้นหา

ค้นเจอ 107 รายการ

Siting

(Environmental Engineering) Obtaining government (federal, state, and local) permission to construct an environmental processing, treatment, or disposal facility at a given site.

Rebound

(Concrete Engineering) Wet shotcrete or sand and cement which bounces away from a surface again at which pneumatically applied mortar is being projected.

ABSOLUTE PRESSURE

(english) The indicated value of the weight of the earth's atmosphere. At sea level, this value is approximately 14.65 psi (pounds per square inch).

Band, Inside

(english) A loose steel frame placed inside a removable flask to reinforce the sand at the parting line after the flask has been removed.

Rod (tamping) (ASTM C24l)

(Concrete Engineering) A round, straight steel rod, 5/8' in diameter and approximately 24' in length, having the tamping end rounded into a hemispherical tip, the diameter of which is 5/8'.

Reversible reaction

(Environmental Engineering) A reaction in which the reactant(s) proceed to product(s), but the products react at an appreciable rate to reform reactant(s).

Irreversible reaction

(Environmental Engineering) A reaction in which the reactant(s) proceed to product(s), but the products react at an appreciable rate to reform reactant(s).

Moist Room

(Concrete Engineering) A room used for storing and curing cementitious test specimens. The atmosphere of this room is maintained at a temperature of 73.4 3.0'F or 23.0*1.7'0 and relative humidity of at least 98 percent. These facilities must be adequate to continually maintain free moisture on the exteriors of test specimens.

Gravity:

(english) An attractive force between two objects; each object accelerates at a rate equal to the attractive force divided by the object's mass. Objects near the surface of the earth tend to accelerate toward the earth's center at a rate of ; this value is often called the gravitational constant and denoted as g.

Aging 2

(english) A change in properties that occurs at ambient or moderately elevated temperatures after hot working or a heat treating operation (quench aging in ferrous alloys), or after a cold working operation (strain aging). The change in properties is often, but not always, due to a phase change (precipitation), but does not involve a change in chemical composition. In a metal or alloy, a change in properties that generally occurs slowly at room temperature and more rapidly at higher temperatures.

Bending Angle

(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.

Baseline

(Software Engineering) a point at which some deliverable produced during the software engineering process is put under formal change contro เส้นอ้างอิง ใช้สำหรับการวางผัง หรือการสำรวจ

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด