ค้นหา "tell the time" ใน คำศัพท์ช่างภาษาอังกฤษ

ผลการค้นหา

ค้นเจอ 595 รายการ

Bearing Strength

(english) The maximum bearing load at failure divided by the effective bearing area. In a pinned or riveted joint, the iffective area is calculated as the product of the diameter of the hole and the thickness of the bearing member.

Bottom Die

(english) The stationary half-die.

THE EMPLOYER

ผู้ว่าจ้าง

Back Rake

(english) The angular surface ground back from the cutting edge of cutting tools. On lathe cutting tools. The rake is positive if the face slopws down from the cutting edge toward the shank, and negative if the face sloopes upward toward the shank.

Bottom Roll

(english) Submerged roll in the pot used to keep the strip submerged in the pot.

Software metrics

(Software Engineering) quantitative measures of the process or the product

Billet container

(english) The part of the extrusion press into which the billet to be extruded is placed.

Butt end

(english) The residual portion of an extrusion billet that is not forced through the die at the end of the extrusion cycle.

Back End

(english) 1) Usually refers to the entry end of process lines. 2) The outside lap 2) of the produced coil, or the inside lap of the consumed coil.

Time-boxing

(Software Engineering) a project scheduling and control technique that establishes time boundaries for the completion of a specific project task

Effluent based standards

(Environmental Engineering) Standards which set concentration or mass per time limits on the effluent being discharged to a receiving water.

Temper

(Concrete Engineering) The addition of water to the cement mix whether at the batch plant, during transit or at the jobsite to achieve the specified water to cement ratio.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด