ผลการค้นหา

ค้นเจอ 609 รายการ

switch on

เปิดไฟ

Bridle Snubber

(english) The roll above the bridle rolls used to thread the strip. Also is used to steer the strip through the bridle.

Source reduction

(Environmental Engineering) The elimination or reduction of the waste at the source by modification of the actual process which produces the waste.

Recycling

(Environmental Engineering) The recovery and reuse of a product which would otherwise be thrown away.

Elastic Shortening

(Concrete Engineering) The shortening of a member in pre-stressed concrete which occurs on the application of forces induced by prestressing.

Reaeration

(Environmental Engineering) The dissolving of molecular oxygen from the atmosphere into the water.

A Elevation

(English) The top level of the boiler firebox where four oil guns are located. The oil guns are used to produce steam and maintain pressure while the boiler is on oil fire.

Maximum Size Aggregate

(Concrete Engineering) Aggregate whose largest particle size is present in sufficient quantity to affect the physical properties of concrete; generally designated by the sieve size on which the maximum amount permitted to be retained is 5 or 10 percent by weight.

Line of Action:

(english) The line of action of a force is the infinite line defined by extending along the direction of the force from the point where the force acts.

Saponification

(Concrete Engineering) The deposit of a gray scum or gray dust on the inside surface of a subgrade wall or floor; as the result of moisture moving through the concrete and washing certain chemicals from the concrete mass.

Bent Axis Pumps

(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump.

Project planning

(Software Engineering) the activity that creates the Project Plan

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด