ค้นหา year-end ใน คำศัพท์ช่างภาษาอังกฤษ

ผลการค้นหา

ค้นเจอ 39 รายการ

front end of armature

ส่วนปลายด้านหัวของทุ่นอาร์มาเชอร์ไดนาโม หรือคอมมิวเตเตอร์

dead end of wire

ปลายสายไฟทั้งคู่ที่ต่อเข้าหากัน

Aldehyde

(Environmental Engineering) An organic compound with a carbonyl at one end of a hydrocarbon group.

WebApps (Web Applications)

(Software Engineering) any application that delivers meaningful content or functionality to end users via the Web.

Big Winch

(english) The tool used to spot (or position) the rail cars for unloading. It is located on the north end of the unloading area.

Bell Mouth

(english) The flaring or tapering of a machined hole, usually made at the entrance end because of misalignment or spring of the cutting tool.

Bevel

(english) Angle formed between the prepared edge of the end of tube and a plane perpendicular to the surface. Standard pipe bevel is 30 degrees.

ACCUMULATOR

(english) A vessel, normally cylindrical, which is used to store fluid and gas for future release of the energy in the compressed fluid and gas. Normally contains a diaphragm or piston between the fluid (liquid) and gas chambers. Fluid is normally introduced at one end and the gas at the opposite end.

Rod (tamping) (ASTM C24l)

(Concrete Engineering) A round, straight steel rod, 5/8' in diameter and approximately 24' in length, having the tamping end rounded into a hemispherical tip, the diameter of which is 5/8'.

Wetland

(Environmental Engineering) Semi-aquatic land, that is land that is either inundated or saturated by water for varying periods of time during each year, and that supports aquatic vegetation which is specifically adapted for saturated soil conditions.

Corrosive waste

(Environmental Engineering) A waste that is outside the pH range of 2 to 12.5 or a waste that corrodes steel at a rate greater than 6.35 mm (0.25 in) per year. One of EPA's four hazardous waste properties.

Bending Angle

(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด