ผลการค้นหา

show through* *show through *show through*

ค้นเจอ 38 รายการ

Bright Drawing

(english) The process of drawing hot rolled steel through a die to impart close dimensional tolerances, a bright scale free surface and improved mechanical properties. The product is termed bright steel.

Butt-Weld Pipe

(english) The standard steel pipe used in plumbing. Heated skelp is passed continuously through welding rolls, which form the tube and squeeze the hot edges together to make a solid weld.

Busheling

(english) A widely traded form of steel scrap consisting of sheet clips and stampings from metal production. Bushel baskets were used to collect the material through World War II, giving rise to the term.

Troposphere

(Environmental Engineering) The lower atmosphere, from the earth's surface to approximately 12 km. This portion of the earth's atmosphere contains about 95 percent of the atmospheric gases. The temperature gradually declines through this region.

BETA RATIO (#)

(english) The amount, expressed as a ratio, of particles in a fluid stream upstream of a filter, after the fluid posses through a filter, divided by the amount of particles downstream, for a particular size particle.

Saponification

(Concrete Engineering) The deposit of a gray scum or gray dust on the inside surface of a subgrade wall or floor; as the result of moisture moving through the concrete and washing certain chemicals from the concrete mass.

Beryllium Copper

(english) An alloy of copper and 2-3% beryllium with optionally fractional percentages of nickel or cobalt. Alloys of this series show remarkable age-hardening properties and an ultimate hardness of about 400 Brinell (Rockwell C43). Because of such hardness and good electrical conductivity, beryllium-copper is used in electrical switches, springs, etc.

Z-Mill

(english) The full name for z-mill is Sendzimir mill. A Z-mill operates with a very small diameter work roll, normally about 2 inches, backed up by a number of rolls in a pyramid-shaped stack. This roll set up allows you to exert extremely high forces through the work roll and yet keep the work roll from extreme flexing. The take-up roll on the Z-Mill also exerts a tension on the coil as it comes through the mill. The combination of high pressure and tension makes the mill capable of rolling material thin and flat.

Impermeable

(Concrete Engineering) The ability of a material or product to reduce or eliminate gaseous transmissions through it's mass; measured as the rate of Water Vapor Transmission (WVT). Note: Not all materials that are waterproof are vaporproof; all materials that are vaporproof are inherently waterproof.

Energy:

(english) A property of a body related to its ability to move a force through a distance opposite the force's direction; energy is the product of the magnitude of the force times the distance. Energy may take several forms: see kinetic energy, potential energy, and elastic energy.

Section Modulus:

(english) A property of a cross sectional shape, which depends on shape, and orientation. Section modulus is usually denoted S, and S = I/c, where I = moment of inertia about an axis through the centroid, and c is the distance from the centroid to the extreme edge of the section.

Moment of inertia (I):

(english) Moment of inertia has two distinct but related meanings: 1) it is a property of a an object relating to the magnitude of the moment required to rotate the object and overcome its inertia. 2) A property of a two dimensional cross section shape with respect to an axis, usually an axis through the centroid of the shape.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด