ผลการค้นหา

round down* *round down *round down*

ค้นเจอ 37 รายการ

down tools

หยุดงาน, วางเครื่องมือ

break down voltage

แรงดันของกระแสไฟชำรุด

down draught carburettor

คาบูเราเตอร์เครื่องยนต์ชนิดที่มีหัวฉีดแก๊สอยู่ข้างล่าง

step down transformer

เครื่องแปลงแรงกระแสไฟให้ลดลง (แปลงแรงสูงเป็นแรงต่ำ)

Bright Bessemer Wire

(english) Stiff bright wire of hard temper. Normally wire is drawn down to size without annealing.

Bright Basic Wire

(english) Bright steel wire, slightly softer than Bright Bessemer Wire. Used for round head wood screws, bolts and rivets, electric welded chain, etc.

Bedding

(english) Sinking a pattern down into the sand to the desired position and ramming the sand around it.

Rod (tamping) (ASTM C24l)

(Concrete Engineering) A round, straight steel rod, 5/8' in diameter and approximately 24' in length, having the tamping end rounded into a hemispherical tip, the diameter of which is 5/8'.

Back Rake

(english) The angular surface ground back from the cutting edge of cutting tools. On lathe cutting tools. The rake is positive if the face slopws down from the cutting edge toward the shank, and negative if the face sloopes upward toward the shank.

Billet 2

(english) A solid semi-finished round or square product that has been hot worked by forging, rolling, or extrusion. An iron or steel billet has a minimum width or thickness of 1 1/2 in. and the cross-sectional area varies from 2 1/4 to 36 sq. in. For nonferrous metals, it may also be a casting suitable for finished or semi-finished rolling or for extrusion.

Blast Furnace

(english) 1) A furnace in which solid fuel (limestone, coke, iron ore) is combined with high-pressure, hot air blast (120,000 psi) to smelt ore in a continuous process (They are never stopped. They can be slowed down or idled). A Blast Furnace in the iron and steel industry is used to produce liquid iron.

Billet

(english) (1) A semi-finished section hot rolled from a metal ingot, with a rectangular cross section usually ranging from 16 to 36 in., the width being less than twice the thickness. Where the cross section exceeds 36 in., the term “bloom” is properly but not universally used. Sizes smaller than 16 in. are usually termed “bars”; a solid semi-finished round or square product which has been hot worked by forging, rolling, or extrusion. (2) A semi-finished, cogged, hot rolled or continuous-cast metal product of uniform section, usually rectangular with radiused corners. Billets are relatively larger than bars.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด