ผลการค้นหา

ค้นเจอ 395 รายการ

FAST

(Software Engineering) Facilitated application specification techniques, a structured meeting between developer and customer; intent is to define basic requirementsFormal methods

Black Annealing

(english) A process of box annealing or pot annealing ferrous alloy sheet, strip or wire after hot working and pickling.

Boiler

(english) A closed vessel in which water, is transformed into steam at a given pressure and temperature under controlled conditions.

Zirconia

(english) ZrO2 an acid refractory up to 2500 B0C (4532 B0F) having good thermal shock resistance and low electrical resistively.

Change management

(Software Engineering) a set of software engineering actions that helps ensure that changes are properly identified, controlled, and reportedChange report

Closure

(Environmental Engineering) The act of preparing a landfill for long term inactivity, including placement of a cover over the landfill to prevent infiltration of surface water.

Secondary treatment

(Environmental Engineering) In wastewater treatment, the conversion of the suspended, colloidal and dissolved organics remaining after primary treatment into a microbial mass with is then removed in a second sedimentation process. Secondary treatment included both the biological process and the associated sedimentation process.

Bent Axis Pumps

(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump.

Boring Tool

(english) A cutting tool in which the tool bit,the boring bar and in some cases the tool holder are incorporated.

In situ treatment

(Environmental Engineering) Treatment of a waste in place, as opposed to pumping or digging the waste up and then treating it.

Change control

(Software Engineering) an umbrella process that enables a project team to accept, evaluate, and act on changes in a systematic manner

Burnt Rubber

(english) Small or large black spots that generally show up on surface and are generally caused by pickling steel too hot.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด