ผลการค้นหา

คำศัพท์ช่างภาษาอังกฤษ - ไทยคำศัพท์/สำนวน ทั้งหมดบทความ
ค้นเจอ 365 รายการ

คำศัพท์ช่างภาษาอังกฤษ - ไทยที่เกี่ยวข้องกับ "English verbs"

คลิกที่แต่ละคำเพื่อดูรายละเอียด

Bearing Load

(english) A compressive load supported by a member, usually a tube or collar, along a line where contact is made with a pin, rivet, axle, or shaft.

Bleeder

(english) A defect wherein a casting lacks completeness due to moltn metal draining or leaking out of some part of the mold cavity after pouraing has stopped.

Basic Steel

(english) Steel melted in a furnace with a basic bottom and lining and under a slag containing an excess of a basic substance such as magnesia or lime.

Back End

(english) 1) Usually refers to the entry end of process lines. 2) The outside lap 2) of the produced coil, or the inside lap of the consumed coil.

Accordion Reed Steel

(english) Hardened, tempered, polished and blued or yellow flat steel with dressed edges. Carbon content about 1.00. Material has to possess good flatness, uniform hardness and high elasticity.

Line of Action:

(english) The line of action of a force is the infinite line defined by extending along the direction of the force from the point where the force acts.

Baller Stick

(english) Octagon-shaped wooden stick approximately 5' long. This stick is used in the baller area, to change burr mashers, to start a coil with a large ID, etc.

Stress:

(english) The intensity of internal force acting at a point in an object. Stress is measured in units of force per area. See shear stress and normal stress.

Resultant:

(english) The resultant of a system of forces is a single force or moment whose magnitude, direction, and location make it statically equivalent to the system of forces.

Shear strain:

(english) Strain measuring the intensity of racking in the material. Shear strain is measured as the change in angle of the corners of a small square of material.

Baked Strength

(english) Compressive, shear, tensile or transverse strength of a mold sand mixture when baked at a temperature above 231 B0F (111 B0C) and then cooled to room temperature.

Bessemer Process

(english) A process for making steel by blowing air through molten pig iron contained in a refractory lined vessel so that the impurities are thus removed by oxidation.

 ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด