ผลการค้นหา

ค้นเจอ 521 รายการ

in whole or partial

ทั้งหมดหรือบางส่วน

Reaeration

(Environmental Engineering) The dissolving of molecular oxygen from the atmosphere into the water.

Water-Cement Ratio

(Concrete Engineering) The ratio of the amount of water, exclusive of that absorbed by the aggregates, to the amount of cement in a concrete mix. Typically expressed as percentage of water, by weight in pounds, to the total weight of portland cement, fly ash, and any other cementitious material, per cubic yard, exclusive of any aggregates.

Flocculant settling

(Environmental Engineering) Settling in which particle concentrations are sufficiently high that particle agglomeration occurs. This results in a reduction in the number of particles and an increase in average particle mass. As agglomeration occurs higher settling velocities result.

Ultimate biochemical oxygen demand (BODu)

(Environmental Engineering) The total amount of oxygen required to oxidize any organic matter present in a water, i.e. after an extended period, such as 20 or 30 days.

Butt-Weld Pipe

(english) The standard steel pipe used in plumbing. Heated skelp is passed continuously through welding rolls, which form the tube and squeeze the hot edges together to make a solid weld.

Plastic Consistency

(Concrete Engineering) Condition in which concrete, mortar, or cement paste will sustain deformation continuously in any direction without rupture.

Hydrologic Cycle

(Concrete Engineering) The Hydrologic Cycle consists of the evaporation of water from oceans and other bodies of open water; condensation to produce cloud formations; precipitation of rain, snow, sleet or hail upon land surfaces; dissipation of rain or melted solids by direct run-off into lakes and by seepage into the soil. Thereby producing a continuing endless source of water in the sub-grade.

Billet

(english) (1) A semi-finished section hot rolled from a metal ingot, with a rectangular cross section usually ranging from 16 to 36 in., the width being less than twice the thickness. Where the cross section exceeds 36 in., the term “bloom” is properly but not universally used. Sizes smaller than 16 in. are usually termed “bars”; a solid semi-finished round or square product which has been hot worked by forging, rolling, or extrusion. (2) A semi-finished, cogged, hot rolled or continuous-cast metal product of uniform section, usually rectangular with radiused corners. Billets are relatively larger than bars.

Trace contaminants

(Environmental Engineering) Contamination found in trace (very low) levels.

Cybernetic

(Environmental Engineering) Systems which change in response to feedback.

Base Metal Contamination

(english) Dirt or other impurities in the steel strip.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด