ผลการค้นหา

stand in for* *stand in for *stand in for*

ค้นเจอ 450 รายการ

Risk

(Software Engineering) a potential problem or occurrence that put a project in jeopardy ความเสี่ยง

Covalent bond

(Environmental Engineering) A bond in which electrons are shared approximately equally by two atoms.

Elementary reaction

(Environmental Engineering) A reaction in which the rate expression corresponds to the stoichiometric equation.

Acid Process 1

(english) A process of making steel, either Bessemer, open-hearth or electric, in which the furnace is lined with a siliceous refractory and for which low phosphorus pig iron is required as this element is not removed.

BETA RATIO (#)

(english) The amount, expressed as a ratio, of particles in a fluid stream upstream of a filter, after the fluid posses through a filter, divided by the amount of particles downstream, for a particular size particle.

Acid-Process

Structural model:

(english) An idealization for analysis purposes of a real or conceived structure. A structural model includes boundaries limiting the scope of the analysis. Supports occur at these boundaries, representing things which hold the structure in place.

Arbitration in the Absence of a Party

วิธีการอนุญาโตตุลาการ ในการตัดสินข้อเรียกร้องหรือข้อพิพาท โดยฝ่ายหนึ่งไม่ได้มาร่วมอยู่ด้วย

Bamboo Grain Structure

(english) A structure in wire or sheet in which the boundaries of the grains tend to be aligned normal to the long axis and to extend completely through the thickness.

Jacking Force

(Concrete Engineering) The temporary force exerted by the jacking device which introduces tension into the tendons. Jacking Stress In prestress concrete, the maximum stress occurring in a tendon during stressing.

Bleeding, Bleed Water

(Concrete Engineering) A form of segregation in which some of the water in a mix tends to rise to the surface of freshly placed concrete. Known also as water gain.

Brown Sharp Gages

(english) A standard series of sizes refered to by numbers, in which the diameter of wire or thickness of sheet metal is generally produced and which is used in the manufacture of brass, bronze, copper, copper-base alloys and aluminum. These gage numbers have a definite relationship to each other. In this system, the decimal thickness is reduced by 50% every six gage numbers- while temper is expressed by the number of B&S gage numbers as cold reduced in thickness from previous annealing. For each B&S gage number in thickness reduction, where is assigned a hardness value of 1/4 hard.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด