ตัวกรองผลการค้นหา
คลิกที่แต่ละคำเพื่อดูรายละเอียด
(Concrete Engineering) A gel-like mass which does not allow the transfer of ions
(English) Coatings on hot-dipped galvanized steels processed to convert the coating completely to zinc-iron alloys; dull gray in appearance, have no spangle, and after proper preparation, are well suited for painting.
(Concrete Engineering) The amount of entrained or entrapped air in concrete or mortar, exclusive of pore space in aggregate particles, usually expressed as a percentage of total volume of concrete or mortar.
(Concrete Engineering) The shortening of a member in pre-stressed concrete which occurs on the application of forces induced by prestressing.
(english) A method of obtaining a high luster on small parts by rotating them in a wooden-lined barrel with water, burnishing soap, and stainless steel shot.
(english) 1) A solution or liquid with a pH less than 7, 2) term applied to slags, refractors, and minerals containing a high percentage of silica.
(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.
(Software Engineering) a project scheduling and control technique that establishes time boundaries for the completion of a specific project task
(Environmental Engineering) A term for several different methods of chemically immobilizing hazardous materials into a cement, plastic, or other matrix.
(english) A device which permits air to move in and out of a container or component to maintain atmospheric pressure.
(Concrete Engineering) To alter composition or physical state by heating to a specific temperature for a specific length of time.
(english) A piece of equipment used for bending sheet; also called a bar folder. If operated manually, it is called a hand brake; if power driven, it is called a press brake.