ผลการค้นหา

ค้นเจอ 157 รายการ

Brazing

(english) Joining metals by fusion of nonferrous alloys that have melting points above 800 F (425C), but lower than those of the metals being joined. May be accomplished by a torch. Filler metal is ordinarily in rod form in torch brazing; whereas in furnace and dip brazing the work material is first assembled and the filler metal may then be applied as wire, washers, clips, bands, or may be bonded, as in brazing sheet.

Base Metal

(english) (1) The metal present in the largest proportion in an alloy; (2) the metal to be brazed, cut or welded; (3) after welding the part of the metal that was not melted during the process.

Plastic

(Concrete Engineering) A condition of freshly mixed concrete. mortar or cement -paste indicating that it is workable and readily re-moldable, is cohesive, and has an ample content of fines and cement but is not over wet.

BETA RATIO (#)

(english) The amount, expressed as a ratio, of particles in a fluid stream upstream of a filter, after the fluid posses through a filter, divided by the amount of particles downstream, for a particular size particle.

Blue Brittleness 2

(english) Reduced ductility occurring as a result of strain aging, when certain ferrous alloys are worked between 300 and 700 (degrees) F. This phenomenon may be observed at the working temperature or subsequently at lower temperatures.

Clarifier (sedimentation basin)

(Environmental Engineering) A tank in which quiescent settling occurs, allowing solid particles suspended in the water to agglomerate and settle to the bottom of the tank. The solids resulting from the settling being removed as a sludge.

Zinc

(english) Chemical Symbol Zn. Element No. 30 of the periodic system; atomic weight 65.38. Blue-white metal; when pure, malleable and ductile even at ordinary temperatures; melting point 787 (degrees) F.; boiling point 1665 (degrees) F., specific gravity 7.14. Can be electrodeposited; it is extensively used as a coating for steel and sheet zinc finds many outlets, such as dry batteries, etc. Zinc-base alloys are of great importance in die casting. Its most important alloy is brass.

Peeling

(Concrete Engineering) A process in which thin flakes of matrix or mortar are broken away from concrete surface; caused by adherence of surface mortar-to forms as forms are removed, or to trowel or float in portland cement plaster.

Saponification

(Concrete Engineering) The deposit of a gray scum or gray dust on the inside surface of a subgrade wall or floor; as the result of moisture moving through the concrete and washing certain chemicals from the concrete mass.

Flocculant settling

(Environmental Engineering) Settling in which particle concentrations are sufficiently high that particle agglomeration occurs. This results in a reduction in the number of particles and an increase in average particle mass. As agglomeration occurs higher settling velocities result.

Back-up Roll

(english) 1) Roll used as a support roll mainly for plater rolls. 2) Two rolls, one on top and one on bottom of the two work rolls which apply pressure and reduce the flexing of the work rolls.

Aging 2

(english) A change in properties that occurs at ambient or moderately elevated temperatures after hot working or a heat treating operation (quench aging in ferrous alloys), or after a cold working operation (strain aging). The change in properties is often, but not always, due to a phase change (precipitation), but does not involve a change in chemical composition. In a metal or alloy, a change in properties that generally occurs slowly at room temperature and more rapidly at higher temperatures.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด