ผลการค้นหา

Agglomerating Processes

แปลว่า(english) "Fine particles of limestone (flux) and iron ore are difficult to handle and transport because of dusting and decomposition, so the powdery material usually is processed into larger pieces. The raw material's properties determine the technique that is used by mills. 1) SINTER Baked particles that stick together in roughly one-inch chunks. Normally used for iron ore dust collected from the blast furnaces. 2) PELLETS Iron ore or limestone particles are rolled into little balls in a balling drum and hardened by heat. 3) BRIQUETTES Small lumps are formed by pressing material together. Hot Iron Briquetting (HBI) is a concentrated iron ore substitute for scrap for use in electric furnaces.

Retempering

แปลว่า(Concrete Engineering) The addition of water and remixing of concrete which has started to stiffen: usually not allowed as it may affect the ultimate strength.

Bimetal

แปลว่า(english) Casting, usually centrifugal, made of two different metals, fused together.

Deflection:

แปลว่า(english) This word usually carries the same meaning as displacement, although it is sometimes used in place of deformation.

Cellular Concrete

แปลว่า(Concrete Engineering) A lightweight product consisting of portland cement, cement-pozzolan, cement sand, lime-pozzolan, or lime-sand pastes, or pastes containing blends of these ingredients and having a homogenous void or cell structure, attained with gas forming chemicals or foaming agents. For cellular concretes, containing binder ingredients other than or in addition to portland cement, autoclave curing is usually employed.

Acid Process 2

แปลว่า(english) A steel making method using an acid refractory-lined (usually silica) furnace. Neither sulfur or phosphorus is removed.

Blow Back

แปลว่า(english) A coating defect consisting of a lower coating film weight on the bottom of the coated sheet caused by high velocity air in the oven. Blow back usually occurs with high solids coatings which have little solvent to evaporate and "set" the film.

Bearing Load

แปลว่า(english) A compressive load supported by a member, usually a tube or collar, along a line where contact is made with a pin, rivet, axle, or shaft.

Billet

แปลว่า(english) (1) A semi-finished section hot rolled from a metal ingot, with a rectangular cross section usually ranging from 16 to 36 in., the width being less than twice the thickness. Where the cross section exceeds 36 in., the term “bloom” is properly but not universally used. Sizes smaller than 16 in. are usually termed “bars”; a solid semi-finished round or square product which has been hot worked by forging, rolling, or extrusion. (2) A semi-finished, cogged, hot rolled or continuous-cast metal product of uniform section, usually rectangular with radiused corners. Billets are relatively larger than bars.

Bell Mouth

แปลว่า(english) The flaring or tapering of a machined hole, usually made at the entrance end because of misalignment or spring of the cutting tool.

Blush

แปลว่า(english) A coating defect consisting of the whitening of a cured film which results in a translucent or opaque appearance with accompanying loss of gloss. Blushing usually occurs during the pasteurization or steam processing of films which are undercured or water sensitive.

BLADDER

แปลว่า(english) A separator or diaphragm usually found in a chamber to facilitate separation of two (2) fluids or gases.