ผลการค้นหา

Bronze

แปลว่า(english) An alloy containing 90% copper and 10% tin. Used for screws, wire, hardware, wear plates, bushings and springs; it is somewhat stronger than copper and brass and has equal or better ductility.

Billet

แปลว่า(english) (1) A semi-finished section hot rolled from a metal ingot, with a rectangular cross section usually ranging from 16 to 36 in., the width being less than twice the thickness. Where the cross section exceeds 36 in., the term “bloom” is properly but not universally used. Sizes smaller than 16 in. are usually termed “bars”; a solid semi-finished round or square product which has been hot worked by forging, rolling, or extrusion. (2) A semi-finished, cogged, hot rolled or continuous-cast metal product of uniform section, usually rectangular with radiused corners. Billets are relatively larger than bars.

B Elevation

แปลว่า(english) The bottom level of the boiler firebox where two oil guns are located. The oil guns are used if the boiler needs extra steam while on oil fire.

Slump Cone

แปลว่า(Concrete Engineering) A metal mold in the form of a truncated cone with a top diameter of 4”, a bottom diameter of 8”, and a height of 12”, used to fabricate the specimen for a slump test.

Bending moment:

แปลว่า(english) A system of internal forces whose resultant is a moment. This term is most commonly used to refer to internal forces in beams.

Test cases, derivation of

แปลว่า(Software Engineering) the creation of data that can be used to uncover errors in the software

Bending Angle

แปลว่า(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.

Kelly Ball

แปลว่า(Concrete Engineering) A device for determining the consistency of fresh concrete. It is sometimes used as an alternative to the slump test.

Bend Test

แปลว่า(english) Various tests which is used to ascertain the toughness and ductility of a metal product, in which the material is bent around its axis and/ or around an outside radius. A complete test might specify such a bend to be both with and against the direction of grain. For testing, samples should be edge filed to remove burrs and any edgewise cracks resulting from slitting or shearing. If a vice is to be employed, then you must line the jaws with some soft metal, to permit a flow of the metal in the piece being tested.

Factoring

แปลว่า(Software Engineering) a technique that distributes control and work in a top-down manner within a software architecture (used a part of structured analysis)

Zircon

แปลว่า(english) The mineral zircon silicate, ZrSiO4, a very high melting point acid refractory material used as a molding material in steel foundries.

Bottom Roll

แปลว่า(english) Submerged roll in the pot used to keep the strip submerged in the pot.