ผลการค้นหา

Statically determinate:

แปลว่า(english) A statically determinate structure is one where there is only one distribution of internal forces and reactions which satisfies equilibrium. In a statically determinate structure, internal forces and reactions can be determined by considering nothing more than equations of equilibrium.

Statically equivalent:

แปลว่า(english) Two force systems are statically equivalent when their resultants are equal. Physically, this means that the force systems tend to impart the same motion when applied to an object; note that the distribution of resulting internal forces in the object may be different.

Statically indeterminate:

แปลว่า(english) A statically indeterminate structure is one where there is more than one distribution of internal forces and/or reactions which satisfies equilibrium.

Acid Process 2

แปลว่า(english) A steel making method using an acid refractory-lined (usually silica) furnace. Neither sulfur or phosphorus is removed.

Make-buy decision

แปลว่า(Software Engineering) determining whether software should be built internally, acquired, contracted or built from reusable components

Blow Back

แปลว่า(english) A coating defect consisting of a lower coating film weight on the bottom of the coated sheet caused by high velocity air in the oven. Blow back usually occurs with high solids coatings which have little solvent to evaporate and "set" the film.

Bearing Load

แปลว่า(english) A compressive load supported by a member, usually a tube or collar, along a line where contact is made with a pin, rivet, axle, or shaft.

Capillarity

แปลว่า(Concrete Engineering) A wick-like action whereby a liquid will migrate vertically through material, in a upward direction; as oil in a lamp travels upward through the wick,

Billet

แปลว่า(english) (1) A semi-finished section hot rolled from a metal ingot, with a rectangular cross section usually ranging from 16 to 36 in., the width being less than twice the thickness. Where the cross section exceeds 36 in., the term “bloom” is properly but not universally used. Sizes smaller than 16 in. are usually termed “bars”; a solid semi-finished round or square product which has been hot worked by forging, rolling, or extrusion. (2) A semi-finished, cogged, hot rolled or continuous-cast metal product of uniform section, usually rectangular with radiused corners. Billets are relatively larger than bars.

Burnt Rubber

แปลว่า(english) Small or large black spots that generally show up on surface and are generally caused by pickling steel too hot.

techical, technically

แปลว่าเฉพาะวิชา, เกี่ยวกับวิชาช่างหรือวิชาพิเศษ เช่น การพิมพ์ การถ่ายรูป, การวิทยุ ฯลฯ

Bell Mouth

แปลว่า(english) The flaring or tapering of a machined hole, usually made at the entrance end because of misalignment or spring of the cutting tool.