ผลการค้นหา

Reactive waste

แปลว่า(Environmental Engineering) A waste which; 1) reacts violently with water, 2) forms potentially explosive mixtures with water, 3) is normally unstable, 4) contains cyanide or sulfide in sufficient quantity to evolve toxic fumes at high or low pH, 5) is capable of exploding if heated under pressure, or 6) is an explosive compound listed in Department of Transportation (DoT) regulations. One of EPA's four hazardous waste properties.

Agglomerating Processes

แปลว่า(english) "Fine particles of limestone (flux) and iron ore are difficult to handle and transport because of dusting and decomposition, so the powdery material usually is processed into larger pieces. The raw material's properties determine the technique that is used by mills. 1) SINTER Baked particles that stick together in roughly one-inch chunks. Normally used for iron ore dust collected from the blast furnaces. 2) PELLETS Iron ore or limestone particles are rolled into little balls in a balling drum and hardened by heat. 3) BRIQUETTES Small lumps are formed by pressing material together. Hot Iron Briquetting (HBI) is a concentrated iron ore substitute for scrap for use in electric furnaces.

ACCUMULATOR

แปลว่า(english) A vessel, normally cylindrical, which is used to store fluid and gas for future release of the energy in the compressed fluid and gas. Normally contains a diaphragm or piston between the fluid (liquid) and gas chambers. Fluid is normally introduced at one end and the gas at the opposite end.

Bright Bessemer Wire

แปลว่า(english) Stiff bright wire of hard temper. Normally wire is drawn down to size without annealing.

BALL VALVE

แปลว่า(english) A valve that may be used to divert the flow of fluid in a passage. Most normally configured in a two-way pattern that is either open or closed.

Z-Mill

แปลว่า(english) The full name for z-mill is Sendzimir mill. A Z-mill operates with a very small diameter work roll, normally about 2 inches, backed up by a number of rolls in a pyramid-shaped stack. This roll set up allows you to exert extremely high forces through the work roll and yet keep the work roll from extreme flexing. The take-up roll on the Z-Mill also exerts a tension on the coil as it comes through the mill. The combination of high pressure and tension makes the mill capable of rolling material thin and flat.