ผลการค้นหา

Detailed Estimate of Construction Cost by the Contractor

แปลว่าการประมาณราคาการก่อสร้างอย่างลงรายละเอียดโดยผู้รับจ้าง

stunt end, form stop end, say joint

แปลว่ารอยหยุดตั้งฉากในการเทคอนกรีต

stunt end, form stop, stop end, say joint

แปลว่ารอยหยุดตั้งฉากในการเทคอนกรีต

joint connecting the two shells of a pearl oyster

แปลว่าขื่อมุก

Thai pattern of Thai construction of common houses without the gable

แปลว่าปั้นหยา

Nonpoint source pollution (NPSP)

แปลว่า(Environmental Engineering) Any pollution from a source which cannot be attributed to a particular discharge point, e.g. from agricultural crops, city streets, construction sites, etc.

Tilt-up

แปลว่า(Concrete Engineering) A method of concrete construction such as where members are cast horizontally near their eventual position, usually on a recently placed slab, and then tilted into place after removal of forms.

Bearing Strength

แปลว่า(english) The maximum bearing load at failure divided by the effective bearing area. In a pinned or riveted joint, the iffective area is calculated as the product of the diameter of the hole and the thickness of the bearing member.

Vibration

แปลว่า(Concrete Engineering) Energetic agitation of concrete to assist in its consolidation, produced by mechanical oscillating devices at moderately high frequencies. (A.) External vibration employs a device attached to the forms and is particularly applicable to the manufacture of precast items and for the vibration of tunnel lining forms. (B.) Internal vibration employs an element which can be inserted into the concrete; and is more generally used for cast-in-place construction.

Bent Axis Pumps

แปลว่า(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump.