ผลการค้นหา

BALL VALVE

แปลว่า(english) A valve that may be used to divert the flow of fluid in a passage. Most normally configured in a two-way pattern that is either open or closed.

Bottle Top Mold

แปลว่า(english) Ingot mold, with the top constricted; used in the manufacture of capped steel, the metal in the constriction being covered with a cap fitting into the bottle-neck, which stops rimming action by trapping escaping gases.

Bridle

แปลว่า(english) A set of rolls used to maintain tension on the strip as it goes through the line.

Beryllium Copper

แปลว่า(english) An alloy of copper and 2-3% beryllium with optionally fractional percentages of nickel or cobalt. Alloys of this series show remarkable age-hardening properties and an ultimate hardness of about 400 Brinell (Rockwell C43). Because of such hardness and good electrical conductivity, beryllium-copper is used in electrical switches, springs, etc.

Tools

แปลว่า(Software Engineering) application software used to perform software engineering tasks (e.g., design tools, testing tools); see also CASE tools

Magnetite

แปลว่า(Concrete Engineering) An aggregate used in heavy weight concrete, consisting primarily of ferrous metaferrite (Fe304). A black magnetic iron ore with a specific gravity of approximately 5.2 and a Mohs hardness of about 6.

Grammatical parse

แปลว่า(Software Engineering) a technique that is used during analysis and intended to help isolate basic data objects and functions

Load:

แปลว่า(english) An external force. The term load is sometimes used to describe more general actions such as temperature differentials or movements such as foundation settlements.

By Coil

แปลว่า(english) Selling term which refers to product sold in the form of a coil vs. cut plate. "Bi Coil" is also used in production to refer to coils vs. cut plate

Back-up Balance

แปลว่า(english) Cylinders that supply the force used to hold the back-up rolls up in place.

Bend Test

แปลว่า(english) Various tests which is used to ascertain the toughness and ductility of a metal product, in which the material is bent around its axis and/ or around an outside radius. A complete test might specify such a bend to be both with and against the direction of grain. For testing, samples should be edge filed to remove burrs and any edgewise cracks resulting from slitting or shearing. If a vice is to be employed, then you must line the jaws with some soft metal, to permit a flow of the metal in the piece being tested.

Factoring

แปลว่า(Software Engineering) a technique that distributes control and work in a top-down manner within a software architecture (used a part of structured analysis)