ผลการค้นหา

Back-up Balance

แปลว่า(english) Cylinders that supply the force used to hold the back-up rolls up in place.

back kick

แปลว่าการกระตุกกลับของเครื่องยนต์แบบเดียวกับ back firing (แบบนี้เกิดขึ้นในขณะใช้คันเหล็กหมุนสตาร์ทเครื่องหน้ารถ เป็นเหตุทำให้ข้อเหวี่ยงของเครื่องยนต์ตีกลับ)

backed-up

แปลว่า(การพิมพ์) แผ่นกระดาษที่พิมพ์ทั้งสองหน้า backed - up erong = แสดงว่าพิมพ์ผิด

Blow Back

แปลว่า(english) A coating defect consisting of a lower coating film weight on the bottom of the coated sheet caused by high velocity air in the oven. Blow back usually occurs with high solids coatings which have little solvent to evaporate and "set" the film.

Back Rake

แปลว่า(english) The angular surface ground back from the cutting edge of cutting tools. On lathe cutting tools. The rake is positive if the face slopws down from the cutting edge toward the shank, and negative if the face sloopes upward toward the shank.

Backer (back-up plate)

แปลว่า(english) A “tool” or reinforcing part, which presses against the outer surface of an extrusion die, supporting it against the pressure of the extruding metal. The backer has an opening larger than the die aperture, allowing the extruded product to emerge without marring its soft surface.

broken-back transition

แปลว่าดู transition, broken-back

Backoff

แปลว่าRemoval of part of coil from entry end of unit; may be necessitated by a defect in coil or by a wreck in the mill, etc. Backoff weight is the part of the coil that is removed and not finished/produced.

Greenhouse gases

แปลว่า(Environmental Engineering) Gases which trap solar radiation. Of the solar energy entering the earth's atmosphere a portion is reflected back and a portion penetrates onto the earth's surface. The portion reflected back from the earth's surface is at a different wavelength that when it entered. Carbon dioxide and other gases, which pass solar radiation, absorb this reflected radiation, increasing the earth's temperature. This is much like a greenhouse, hence the name.

Z-Mill

แปลว่า(english) The full name for z-mill is Sendzimir mill. A Z-mill operates with a very small diameter work roll, normally about 2 inches, backed up by a number of rolls in a pyramid-shaped stack. This roll set up allows you to exert extremely high forces through the work roll and yet keep the work roll from extreme flexing. The take-up roll on the Z-Mill also exerts a tension on the coil as it comes through the mill. The combination of high pressure and tension makes the mill capable of rolling material thin and flat.

Backing Board (Backing Plate)

แปลว่า(english) A second bottom board on which molds are opened.

back slope

แปลว่าเชิ่งลาดด้านหลัง ส่วนลาดเอนด้านหลังของกำแพงกันดิน