ผลการค้นหา

Component (of a vector):

แปลว่า(english) Any vector can be expressed as a collection of vectors whose sum is equal to the original vector. Each vector in this collection is a component of the original vector. It is common to express a vector in terms of components which are parallel to the x and y axes.

Stress resultant:

แปลว่า(english) A system of forces which is statically equivalent to a stress distribution over an area.

Bright Bessemer Wire

แปลว่า(english) Stiff bright wire of hard temper. Normally wire is drawn down to size without annealing.

Billet container

แปลว่า(english) The part of the extrusion press into which the billet to be extruded is placed.

Groundwater

แปลว่า(Environmental Engineering) Water which is contained in geologic strata. Also properly written as two words, ground water.

Non-evaporable Water

แปลว่า(Concrete Engineering) The water in concrete which is irremovable by oven drying; chemically combined during cement hydration.

Change control authority (CCA)

แปลว่า(Software Engineering) the person(s) who have responsibility for deciding whether a change is to be made

Blast Furnace Gas

แปลว่า(english) By-product gas created by the iron making process which is used as fuel for the boilers.

Box Annealing

แปลว่า(english) Annealing a metal or alloy in a sealed container under conditions that minimize oxidation. In box annealing a ferrous alloy, the charge is usually heated slowly to a temperature below the transformation range, but sometimes above or within it, and is then cooled slowly; this process is also called close annealing or pot annealing.

Automatic code generation

แปลว่า(Software Engineering) tools that generate source code from a representation of software that is not source code

Ac3

แปลว่า(english) In hypoeutectoid steel, the temperature at which transformation of ferrite into austenite is completed upon heating.

Billet

แปลว่า(english) (1) A semi-finished section hot rolled from a metal ingot, with a rectangular cross section usually ranging from 16 to 36 in., the width being less than twice the thickness. Where the cross section exceeds 36 in., the term “bloom” is properly but not universally used. Sizes smaller than 16 in. are usually termed “bars”; a solid semi-finished round or square product which has been hot worked by forging, rolling, or extrusion. (2) A semi-finished, cogged, hot rolled or continuous-cast metal product of uniform section, usually rectangular with radiused corners. Billets are relatively larger than bars.