ผลการค้นหา

Water Vapor Pressure

แปลว่า(Concrete Engineering) The pressure exerted by water vapor. Air that contains higher amounts of water vapor exerts a higher vapor pressure than air which has a lower amount of has a higher water vapor pressure In concrete water vapor pressure is calculated by the difference between the vapor pressure of the concrete and the ambient relative humidity and temperature and in contact with the soil. that is calculated by; based upon relative humidity and temperature. The greater the difference between the water vapor and ambient humidity and temperature, in degrees Fahrenheit. the greater the water vapor pressure exerted.

Shear:

แปลว่า(english) An system of internal forces whose resultant is a force acting perpendicular to the longitudinal axis of a structural member or assembly: sometimes called shear force.

Baller Stick

แปลว่า(english) Octagon-shaped wooden stick approximately 5' long. This stick is used in the baller area, to change burr mashers, to start a coil with a large ID, etc.

Normal stress:

แปลว่า(english) Stress acting perpendicular to an imaginary plane cutting through an object. Normal stress has two senses: compression and tension. Normal stress is often simply called stress.

Bearing Load

แปลว่า(english) A compressive load supported by a member, usually a tube or collar, along a line where contact is made with a pin, rivet, axle, or shaft.

Blast Furnace 2

แปลว่า(english) A vertical shaft type smelting furnace in which an air blast is used, usually hot, for producing pih iron. The furnace is continuous in operation using iron ore, coke, and limestone as raw materials which are charged at the top while the molten iron and slag are collected at the bottom and are tapped out at intervals.

Barrel (of cement)

แปลว่า(Concrete Engineering) A unit of weight for cement: 376 Ibs net, equivalent to 4 US bags of portland cement. The designation presently used is tons of cement.

Consolidation

แปลว่า(Concrete Engineering) Compaction usually accomplished by vibration of newly placed concrete to minimum practical volume, to mold it within form shapes and around embedded parts and reinforcement, and to eliminate voids other than entrained air.

Cold Joint

แปลว่า(Concrete Engineering) A visible lineation which forms when the placement of concrete is delayed. The concrete in place hardens prior to the next placement of concrete against it.

Adiabatic Curing

แปลว่า(Concrete Engineering) The maintenance of ambient conditions during the setting and hardening of concrete so that heat is neither lost nor gained from the surroundings of the concrete.

Trophic level

แปลว่า(Environmental Engineering) A level in the food chain. The first trophic level consists of the primary producers, autotrophs. The second trophic level is vegetarians which consume autotrophic organisms.

Keene's Cement

แปลว่า(Concrete Engineering) A finely ground high density plaster composed of anhydrous, (calcined or "dead burned") gypsum, the set of which is accelerated by the addition of other materials.