ผลการค้นหา

Backing Sand

แปลว่า(english) The bulk of the sand in the flask. The sand compacted on top of the facing sand that covers the pattern.

Bending Angle

แปลว่า(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.

Blister 2

แปลว่า(english) A defect in metal, on or near the surface, resulting from the expansion of gas in a subsurface zone. Very small blisters are called pinheads or pepper blisters.

Chair(s)

แปลว่า(Concrete Engineering) In concrete formwork, the support for the reinforcing steel.

BALL VALVE

แปลว่า(english) A valve that may be used to divert the flow of fluid in a passage. Most normally configured in a two-way pattern that is either open or closed.

Bottle Top Mold

แปลว่า(english) Ingot mold, with the top constricted; used in the manufacture of capped steel, the metal in the constriction being covered with a cap fitting into the bottle-neck, which stops rimming action by trapping escaping gases.

Bleeding, Bleed Water

แปลว่า(Concrete Engineering) A form of segregation in which some of the water in a mix tends to rise to the surface of freshly placed concrete. Known also as water gain.

Blowhole

แปลว่า(english) A defect in a casting caused by trapped steam or gas.

Bright Annealing 2

แปลว่า(english) The process of annealing in a protective atmosphere so as to prevent discoloration of the bright surface desired.

Engineering change order (ECO)

แปลว่า(Software Engineering) a mini-specification that describes the technical aspects of a change

Design specification

แปลว่า(Software Engineering) a document that describes the design

Hypolimnion

แปลว่า(Environmental Engineering) The lower layer of a lake.