ผลการค้นหา

Customer

แปลว่า(Software Engineering) the person or group that has requested the software and will be paying the bill for its development

Blow Back

แปลว่า(english) A coating defect consisting of a lower coating film weight on the bottom of the coated sheet caused by high velocity air in the oven. Blow back usually occurs with high solids coatings which have little solvent to evaporate and "set" the film.

Black box testing

แปลว่า(Software Engineering) testing that does not focus on the internal details of the program but uses external requirements

Decomposers

แปลว่า(Environmental Engineering) Organisms which utilize energy from wastes or dead organisms. Decomposers complete the cycle by returning nutrients to the soil or water and carbon dioxide to the air or water.

Bending

แปลว่า(english) A preliminary forging operation to give the piece approximately the correct shape for subsequent forming.

Advanced wastewater treatment

แปลว่า(Environmental Engineering) The removal of any dissolved or suspended contaminants beyond secondary treatment, often this is the removal of the nutrients nitrogen and/or phosphorus.

Right of Access to the Site

แปลว่าสิทธิในการเข้าพื้นที่ก่อสร้าง

Preliminary design

แปลว่า(Software Engineering) creates representation of the data and architecture

Fixed suspended solids

แปลว่า(Environmental Engineering) (FSS) is the matter remaining from the suspended solids analysis which will not burn at 550°C. It represents the non-filterable inorganic residue in a sample.

Stress:

แปลว่า(english) The intensity of internal force acting at a point in an object. Stress is measured in units of force per area. See shear stress and normal stress.

Capillarity

แปลว่า(Concrete Engineering) A wick-like action whereby a liquid will migrate vertically through material, in a upward direction; as oil in a lamp travels upward through the wick,

Billet

แปลว่า(english) (1) A semi-finished section hot rolled from a metal ingot, with a rectangular cross section usually ranging from 16 to 36 in., the width being less than twice the thickness. Where the cross section exceeds 36 in., the term “bloom” is properly but not universally used. Sizes smaller than 16 in. are usually termed “bars”; a solid semi-finished round or square product which has been hot worked by forging, rolling, or extrusion. (2) A semi-finished, cogged, hot rolled or continuous-cast metal product of uniform section, usually rectangular with radiused corners. Billets are relatively larger than bars.