ผลการค้นหา

Calcium Aluminate Cement

แปลว่า(Concrete Engineering) The product obtained by pulverizing clinker consisting essentially of hydraulic calcium aluminates resulting from fusing or sintering a suitable proportioned mixture of aluminous and calcareous materials.

head, pressure

แปลว่าเฮดความดัน : ความสูงของเส้น hydraulic grade line เหนือจุด ๆ หนึ่งหาได้จากอัตราส่วนระหว่างแรงกดดัน (น.น/หน่วยพื้นที่) ต่อน้ำหนักจำเพาะของของเหลว (น.น./หน่วยปริมาตร)มีหน่วยเป็นความสูง

Aluminous Cement

แปลว่า(Concrete Engineering) A hydraulic cement in which the principal constituents are calcium aluminates, instead of calcium silicates which comprise the major ingredients of portland cement. (See calcium aluminate cement)

Air Entraining Agent

แปลว่า(Concrete Engineering) An addition for hydraulic cement, or an admixture for concrete or mortar which entrains air in the form of minute bubbles in the concrete or mortar during mixing.

ADAPTER

แปลว่า(english) A mechanical device used to align the shaft of an electric motor (or other rotary device) with the shaft of a hydraulic pump to maintain radial and parallel shaft alignment.

Cement, Portland (ASTM C150) (Concrete Engineering)

แปลว่าA powdery substance made by burning, at a high temperature, a mixture of clay and limestone producing lumps called “clinkers” which are ground into a fine powder consisting of hydraulic calcium silicates. For non-portland cements, see aluminous cement.

Gillmore Needle

แปลว่า(Concrete Engineering) A device used in determining time of setting of hydraulic cement, described in ASTM 0 266. Gradation The sizing of granular materials; for concrete materials, usually expressed in terms of cumulative percentages larger or smaller than each of a series of sieve openings or the percentages between certain ranges of sieve openings.

Bend Test

แปลว่า(english) Various tests which is used to ascertain the toughness and ductility of a metal product, in which the material is bent around its axis and/ or around an outside radius. A complete test might specify such a bend to be both with and against the direction of grain. For testing, samples should be edge filed to remove burrs and any edgewise cracks resulting from slitting or shearing. If a vice is to be employed, then you must line the jaws with some soft metal, to permit a flow of the metal in the piece being tested.