ผลการค้นหา

Go, no-go decision

แปลว่า(Software Engineering) a point at which manager or the customer decides whether the project should proceed

Bench Work

แปลว่า(english) Work done primarily at a bench with hand tools. Occasionlly suplemented by small power-driven tools.

Bending Strength

แปลว่า(english) Upper limit of normal stress of a beam at which fracture or excessive plastic deformation occurs.

Strain:

แปลว่า(english) The intensity of deformation at a point in an object. See normal strain and shear strain.

Ac3

แปลว่า(english) In hypoeutectoid steel, the temperature at which transformation of ferrite into austenite is completed upon heating.

Blast Furnace 2

แปลว่า(english) A vertical shaft type smelting furnace in which an air blast is used, usually hot, for producing pih iron. The furnace is continuous in operation using iron ore, coke, and limestone as raw materials which are charged at the top while the molten iron and slag are collected at the bottom and are tapped out at intervals.

Blue Brittleness 2

แปลว่า(english) Reduced ductility occurring as a result of strain aging, when certain ferrous alloys are worked between 300 and 700 (degrees) F. This phenomenon may be observed at the working temperature or subsequently at lower temperatures.

Paper prototype

แปลว่า(Software Engineering) a paper representation of an application (e.g., story boards that describe the interaction at a human interface)

Adsorption

แปลว่า(Environmental Engineering) A surface phenomena in which a solute (soluble material) concentrates or collects at a surface (the adsorbent).

Boiler

แปลว่า(english) A closed vessel in which water, is transformed into steam at a given pressure and temperature under controlled conditions.

Anoxic process

แปลว่า(Environmental Engineering) A process which occurs only at very low levels of molecular oxygen or in the absence of molecular oxygen.

Ductility:

แปลว่า(english) Ductility generally refers to the amount of inelastic deformation which a material or structure experiences before complete failure. Quantitatively, ductility can be defined as the ratio of the total displacement or strain at failure, divided by the displacement or strain at the elastic limit.