ผลการค้นหา

Bull Gear

แปลว่า(english) The large crank gear of a shaper.

Elastic Shortening

แปลว่า(Concrete Engineering) The shortening of a member in pre-stressed concrete which occurs on the application of forces induced by prestressing.

Burnishing

แปลว่า(english) Developing a smooth finish on a metal by tumbling or rubbing with a polished hand tool.

Activation

แปลว่า(english) The changing of the passive surface of a metal to a chemically active state. Contrast with passivation.

Brinell Hardness Test

แปลว่า(english) A common standard method of measuring the hardness of materials. The smooth surface of the metal is subjected to indentation by a hardened steel ball under pressure. The diameter of the indentation, in the material surface, is then measured by a microscope and the hardness value is read from a chart or determined by a prescribed formula.

Component (of a vector):

แปลว่า(english) Any vector can be expressed as a collection of vectors whose sum is equal to the original vector. Each vector in this collection is a component of the original vector. It is common to express a vector in terms of components which are parallel to the x and y axes.

Belly Roll

แปลว่า(english) Roll used on the line to steady plate.

Base

แปลว่า(english) The steel or concrete pedestal on which the coils are stacked during the batch annealing process.

Weight:

แปลว่า(english) The force on an object resulting from gravity.

Z-Mill

แปลว่า(english) The full name for z-mill is Sendzimir mill. A Z-mill operates with a very small diameter work roll, normally about 2 inches, backed up by a number of rolls in a pyramid-shaped stack. This roll set up allows you to exert extremely high forces through the work roll and yet keep the work roll from extreme flexing. The take-up roll on the Z-Mill also exerts a tension on the coil as it comes through the mill. The combination of high pressure and tension makes the mill capable of rolling material thin and flat.

Rotation:

แปลว่า(english) Motion of an object where the path of every point is a circle or circular arc. A rotation is defined by a point and vector which determine the axis of rotation. The direction of the vector is the direction of the axis and the magnitude of the vector is the angle of rotation.

Classes - a basic construct in object

แปลว่า(Software Engineering) oriented methods that categorizes elements of the problem