ผลการค้นหา

Roller support:

แปลว่า(english) In two dimensions, a roller support restrains one translation degree of freedom.

Detail design

แปลว่า(Software Engineering) a design activity that focuses on the creation of an algorithm

Total suspended solids

แปลว่า(Environmental Engineering) (TSS) is the amount of suspended (filterable) matter in a water.

Backoff

แปลว่าRemoval of part of coil from entry end of unit; may be necessitated by a defect in coil or by a wreck in the mill, etc. Backoff weight is the part of the coil that is removed and not finished/produced.

Abrasion 1

แปลว่า(english) The displacement and/or detachment of metallic particles from a surface as a consequence of being exposed to flowing solids, fluids or gases. The process of rubbing, grinding, or wearing away by friction.

Block Off

แปลว่า(english) 1) Wooden separators which are used at both the bottom of a lift and between IPM's (bundles) of a lift. 2) The act of placing 4x4s between the lifts in the piler's box.

Stiffness:

แปลว่า(english) This is a general term which may be applied to materials or structures. When a force is applied to a structure, there is a displacement in the direction of the force; stiffness is the ratio of the force divided by the displacement. High stiffness means that a large force produces a small displacement. When discussing the stiffness of a material, the concept is the same, except that stress substitutes for force, and strain substitutes for displacement; see modulus of elasticity.

Amino acid

แปลว่า(Environmental Engineering) A functional group which consists of a carbon with a carboxylic acid, "-COOH" and an amine, "-NH2." These compounds are the building blocks for proteins.

Bench Lathe

แปลว่า(english) A small lathe mounted on a bench or table.

Butcher Saw Steel

แปลว่า(english) A hardened, tempered, and polished high carbon spring steel strip material (carbon content is generally higher than that of a material used for wood band saw applications) with a Rockwell value of roughly C47/49.

Bearing Load

แปลว่า(english) A compressive load supported by a member, usually a tube or collar, along a line where contact is made with a pin, rivet, axle, or shaft.

Bending Angle

แปลว่า(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.