ผลการค้นหา

route

แปลว่าการเดินทาง, เส้นทาง, วางเส้น

Blue Vitriol Copper sulfate

แปลว่า(english) A layout solution which turns a copper color when applied to a clean,polished metal surface.

outside callipers

แปลว่าวงเวียนสำหรับวัดเส้น หรือระยะของวงกลมด้านนอก

Bent Axis Pumps

แปลว่า(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump.

out flow

แปลว่าการไหลออกมา

outlining

แปลว่าการลากเส้นรอบนอก, การสะเก๊ตภาพ, การร่างขึ้นเป็นเลา ๆ

southwest monsoon

แปลว่าลมตะเภา, มรสุมจากใต้

outgate

แปลว่าประตูทางออก

outer

แปลว่ากำแพงชั้นนอก

Body force:

แปลว่า(english) An external force acting throughout the mass of a body. Gravity is a body force. An inertial force is a body force.

Pin support:

แปลว่า(english) In two dimensions, a pin support restrains two translation degrees of freedom but does not restrain rotation. When considering reaction forces, a pin support is usually considered to have two force components: one each about the x and y axes respectively.

Brinell Hardness Testing

แปลว่า(english) Method of determining the hardness of materials; involves impressing a hardened ball of specified diameter into the material surface at a known pressure (10-mm ball, 500-kg load for aluminum alloys). The Brinell hardness number results from calculations involving the load and the spherical area of the ball impression. Direct-reading testing are generally used for routine inspection of forgings, and as a heat treat control function.