ตัวกรองผลการค้นหา
Secondary standards
แปลว่า(Environmental Engineering) Recommended drinking water quality standards which relate to aesthetics and/or health. These standards are recommended, not required. See primary standards.
Interoperability
แปลว่า(Software Engineering) the degree to which one application communicates or interfaces with another
Air Entraining Agent
แปลว่า(Concrete Engineering) An addition for hydraulic cement, or an admixture for concrete or mortar which entrains air in the form of minute bubbles in the concrete or mortar during mixing.
Ultimate disposal
แปลว่า(Environmental Engineering) The process of returning residuals back to the environment in a form which will have the minimal or reduced negative environmental impacts.
Basic Steel
แปลว่า(english) Steel melted in a furnace with a basic bottom and lining and under a slag containing an excess of a basic substance such as magnesia or lime.
External force:
แปลว่า(english) A surface force or body force acting on an object. External forces are sometimes called applied forces.
Bonderized Coating
แปลว่า(english) A thin film of phosphate pretreatment applied to a steel surface (bare or zinc coated) to enhance paintability.
Bamboo Grain Structure
แปลว่า(english) A structure in wire or sheet in which the boundaries of the grains tend to be aligned normal to the long axis and to extend completely through the thickness.
Brown Sharp Gages
แปลว่า(english) A standard series of sizes refered to by numbers, in which the diameter of wire or thickness of sheet metal is generally produced and which is used in the manufacture of brass, bronze, copper, copper-base alloys and aluminum. These gage numbers have a definite relationship to each other. In this system, the decimal thickness is reduced by 50% every six gage numbers- while temper is expressed by the number of B&S gage numbers as cold reduced in thickness from previous annealing. For each B&S gage number in thickness reduction, where is assigned a hardness value of 1/4 hard.
Broaching
แปลว่า(english) Smoothing machined holes or outside surfaces of castings by drawing pushing on or more broaches (special cutting tools) through the roughed out hole.
Risk
แปลว่า(Software Engineering) a potential problem or occurrence that put a project in jeopardy ความเสี่ยง
Data objects
แปลว่า(Software Engineering) an input or output that is user visible