ผลการค้นหา

ค้นเจอ 635 รายการ

Chair(s)

(Concrete Engineering) In concrete formwork, the support for the reinforcing steel.

Broaching 2

(english) Multiple shaving, accomplished by pushing a tool with stepped cutting edges along the piece, particularly through holes.

Saltwater intrusion

(Environmental Engineering) The gradual replacement of freshwater by saltwater in coastal areas where excessive pumping of groundwater occurs.

Burr

(english) The very subtle ridge on the edge of strip steel left by cutting operations such as slitting, trimming, shearing, or blanking. For example, as a steel processor trims the sides of the sheet steel parallel or cuts a sheet of steel into strips, its edges will bend with the direction of the cut.

Base Metal

(english) (1) The metal present in the largest proportion in an alloy; (2) the metal to be brazed, cut or welded; (3) after welding the part of the metal that was not melted during the process.

Paradigms

(Software Engineering) the process model

Burning

(english) (1) Permanently damaging a metal or alloy by heating to cause either incipient melting or intergranular oxidation. (2) In grinding getting the work hot enough to cause discoloration or to change the microstructure by tempering or hardening.

Big Winch

(english) The tool used to spot (or position) the rail cars for unloading. It is located on the north end of the unloading area.

Bedding

(english) Sinking a pattern down into the sand to the desired position and ramming the sand around it.

Compression settling

(Environmental Engineering) Settling which occurs in the lower reaches of clarifiers where particle concentrations are highest. Particles can settle only by compressing the mass of particles below.

Bent Axis Pumps

(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump.

Flexure:

(english) Bending deformation, i.e., deformation by increasing curvature.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด