ผลการค้นหา

be done with* *be done with *be done with*
คำศัพท์ช่างภาษาอังกฤษ - ไทยคำศัพท์/สำนวน ทั้งหมดบทความ
ค้นเจอ 174 รายการ

คำศัพท์ช่างภาษาอังกฤษ - ไทยที่เกี่ยวข้องกับ "be done with"

คลิกที่แต่ละคำเพื่อดูรายละเอียด

Task analysis

(Software Engineering) a software engineering action that is conducted as part of user interface design; intended to better understand how a user is to interact with a system

Basic Steel

(english) Steel melted in a furnace with a basic bottom and lining and under a slag containing an excess of a basic substance such as magnesia or lime.

Accordion Reed Steel

(english) Hardened, tempered, polished and blued or yellow flat steel with dressed edges. Carbon content about 1.00. Material has to possess good flatness, uniform hardness and high elasticity.

Baller Stick

(english) Octagon-shaped wooden stick approximately 5' long. This stick is used in the baller area, to change burr mashers, to start a coil with a large ID, etc.

Debugging

(Software Engineering) the activity associated with finding and correcting an error or defect - a lack of conformance to requirements found in the software after delivery to the customer

Bamboo Grain Structure

(english) A structure in wire or sheet in which the boundaries of the grains tend to be aligned normal to the long axis and to extend completely through the thickness.

BACK-UP RING

(english) A fabric or plastic device that is used with an o-ring or other gasket to prevent extrusion of the o-ring or gasket into an adjacent space or crevice

Bentonite

(english) A colloidal clay derived from volcanic ash and employed as a binder in connection with synthetic sands, or added to ordinary natural (clay-bonded) sands where extra strength is required.

Blow Down

(english) Process that rids boiler feed water of solids and maintains the proper chemical balance of the feed water. Blow down can also be used to rid drum(s) of excess water.

Patterns

(Software Engineering) a stylized description or characterization of a software problem or capability and/or the manner in which a solution to the problem or capability may be characterized, applied, and implemented

ADAPTER

(english) A mechanical device used to align the shaft of an electric motor (or other rotary device) with the shaft of a hydraulic pump to maintain radial and parallel shaft alignment.

Sacking

(Concrete Engineering) Removing or alleviating defects on a concrete surface by applying a mixture of sand and cement to the moistened surface and rubbing with a coarse material such as burlap.

 ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด