ตัวกรองผลการค้นหา
Truck Mixer
แปลว่า(Concrete Engineering) A concrete mixer capable of mixing concrete in transit when mounted on a truck chassis.
Interface design
แปลว่า(Software Engineering) a software engineering action that establishes the structure and workflow for a user interface; follows three "golden rules:" place the user in control, reduce the user's memory leoad, make the interface consistent.
Bending
แปลว่า(english) A preliminary forging operation to give the piece approximately the correct shape for subsequent forming.
Go, no-go decision
แปลว่า(Software Engineering) a point at which manager or the customer decides whether the project should proceed
Ac1
แปลว่า(english) The temperature at which austenite begins to form on heating.
Boring Tool
แปลว่า(english) A cutting tool in which the tool bit,the boring bar and in some cases the tool holder are incorporated.
Burr
แปลว่า(english) The very subtle ridge on the edge of strip steel left by cutting operations such as slitting, trimming, shearing, or blanking. For example, as a steel processor trims the sides of the sheet steel parallel or cuts a sheet of steel into strips, its edges will bend with the direction of the cut.
Back Rake
แปลว่า(english) The angular surface ground back from the cutting edge of cutting tools. On lathe cutting tools. The rake is positive if the face slopws down from the cutting edge toward the shank, and negative if the face sloopes upward toward the shank.
Spall
แปลว่า(Concrete Engineering) A fragment, usually of flaky shape, detached from a larger mass by pressure, expansion from within the larger mass, a blow, or by the action of weather.
Block Off
แปลว่า(english) 1) Wooden separators which are used at both the bottom of a lift and between IPM's (bundles) of a lift. 2) The act of placing 4x4s between the lifts in the piler's box.
Software problem report
แปลว่า(Software Engineering) a report of a defect
Blow Back
แปลว่า(english) A coating defect consisting of a lower coating film weight on the bottom of the coated sheet caused by high velocity air in the oven. Blow back usually occurs with high solids coatings which have little solvent to evaporate and "set" the film.