ผลการค้นหา

Saponification

แปลว่า(Concrete Engineering) The deposit of a gray scum or gray dust on the inside surface of a subgrade wall or floor; as the result of moisture moving through the concrete and washing certain chemicals from the concrete mass.

Project scope

แปลว่า(Software Engineering) a statement of basic requirements of the software to be built

Block Off

แปลว่า(english) 1) Wooden separators which are used at both the bottom of a lift and between IPM's (bundles) of a lift. 2) The act of placing 4x4s between the lifts in the piler's box.

Bright Annealing 2

แปลว่า(english) The process of annealing in a protective atmosphere so as to prevent discoloration of the bright surface desired.

Consistency

แปลว่า(Concrete Engineering) The degree of plasticity of fresh concrete or mortar The normal measure of consistency is slump for concrete and flow for mortar.

Component (of a vector):

แปลว่า(english) Any vector can be expressed as a collection of vectors whose sum is equal to the original vector. Each vector in this collection is a component of the original vector. It is common to express a vector in terms of components which are parallel to the x and y axes.

Barrel (of cement)

แปลว่า(Concrete Engineering) A unit of weight for cement: 376 Ibs net, equivalent to 4 US bags of portland cement. The designation presently used is tons of cement.

Kinetic Energy:

แปลว่า(english) The energy of a moving mass; equal to (mv^2)2. Where m is mass and v is the magnitude of the velocity.

ABSOLUTE PRESSURE

แปลว่า(english) The indicated value of the weight of the earth's atmosphere. At sea level, this value is approximately 14.65 psi (pounds per square inch).

Mass balance

แปลว่า(Environmental Engineering) An organized accounting of all inputs and outputs to an arbitrary but defined system. Stated in other terms, the rate of mass accumulation within a system is equal to the rate of mass input less the rate of mass output plus the rate of mass generation within the system.

Boron Steels

แปลว่า(english) The addition of boron in the range 0.0005-0.005% to certain steels increases the hardenability. A range of boron steels is now listed in the current BS 970 and are widely used for the production of cold headed fastenings.

Design walkthrough

แปลว่า(Software Engineering) a formal technical review of the design