ผลการค้นหา

ค้นเจอ 614 รายการ

Burning

(english) (1) Permanently damaging a metal or alloy by heating to cause either incipient melting or intergranular oxidation. (2) In grinding getting the work hot enough to cause discoloration or to change the microstructure by tempering or hardening.

Big Winch

(english) The tool used to spot (or position) the rail cars for unloading. It is located on the north end of the unloading area.

Bedding

(english) Sinking a pattern down into the sand to the desired position and ramming the sand around it.

Compression settling

(Environmental Engineering) Settling which occurs in the lower reaches of clarifiers where particle concentrations are highest. Particles can settle only by compressing the mass of particles below.

Bent Axis Pumps

(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump.

Flexure:

(english) Bending deformation, i.e., deformation by increasing curvature.

Bench Rammer

(english) A short rammer used by bench molders.

Infectious disease

(Environmental Engineering) A disease caused by pathogenic organisms.

Holding Period Period

(Concrete Engineering) In the manufacture of concrete products, the period between completion of casting and the introduction of additional heat or the steam curing period

Dispersing Agent

(Concrete Engineering) An admixture capable of increasing the fluidity of pastes, mortars, or concretes by reduction of interparticle attraction.

Boil

(english) Agitation of a bath of metal caused by the liberation of a gas beneath its surface. May be deliberately induced by the addition of oxidizing material to a bath containing excess carbon. In the later case it is called a carbon boil and CO or CO2 are liberated.

voltage regulation by brush shifting

การปรับกำลังดันของไฟฟ้า โดยการเลื่อนระยะของแปรงถ่าน (เครื่องกำเนิดไฟฟ้า)

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด