ผลการค้นหา

Reactive waste

แปลว่า(Environmental Engineering) A waste which; 1) reacts violently with water, 2) forms potentially explosive mixtures with water, 3) is normally unstable, 4) contains cyanide or sulfide in sufficient quantity to evolve toxic fumes at high or low pH, 5) is capable of exploding if heated under pressure, or 6) is an explosive compound listed in Department of Transportation (DoT) regulations. One of EPA's four hazardous waste properties.

Corrosive waste

แปลว่า(Environmental Engineering) A waste that is outside the pH range of 2 to 12.5 or a waste that corrodes steel at a rate greater than 6.35 mm (0.25 in) per year. One of EPA's four hazardous waste properties.

Section Modulus:

แปลว่า(english) A property of a cross sectional shape, which depends on shape, and orientation. Section modulus is usually denoted S, and S = I/c, where I = moment of inertia about an axis through the centroid, and c is the distance from the centroid to the extreme edge of the section.

Vapor Pressure

แปลว่า(Concrete Engineering) The pressure exerted by a vapor that is calculated based upon relative humidity and temperature. The higher the humidity and higher temperature, in degrees Fahrenheit, the greater the vapor pressure exerted.

Backoff

แปลว่าRemoval of part of coil from entry end of unit; may be necessitated by a defect in coil or by a wreck in the mill, etc. Backoff weight is the part of the coil that is removed and not finished/produced.

Butt-Weld Pipe

แปลว่า(english) The standard steel pipe used in plumbing. Heated skelp is passed continuously through welding rolls, which form the tube and squeeze the hot edges together to make a solid weld.

Strength:

แปลว่า(english) A very general term that may be applied to a material or a structure. In a material, strength refers to a level of stress at which there is a significant change in the state of the material, e.g., yielding or rupture. In a structure, strength refers to a level of level of loading which produces a significant change in the state of the structure, e.g., inelastic deformations, buckling, or collapse.

Acid Process 2

แปลว่า(english) A steel making method using an acid refractory-lined (usually silica) furnace. Neither sulfur or phosphorus is removed.

Batch Anneal

แปลว่า(english) The process by which a large, stationary stack of steel coils (4 coils high) is subjected to a long heat-treating cycle. This process enables the cold-rolled sheet to fully recrystallize into the softest possible product conforming to customer specifications. Controlling the recrystallization process makes a fine-grained microstructure easy to obtain, and minimizes the tendencies for retention of directional properties of the rolled steel which could produce undesirable shapes in the stamping of a cylindrical part such as a can. Also see Anneal and Continuous Anneal.

Elastic energy:

แปลว่า(english) The energy stored in deformed elastic material (e.g., a watch spring). Elastic energy equals where k is the stiffness, and is the associated deflection. Elastic energy is sometimes called elastic potential energy because it can be recovered when the object returns to its original shape; see potential energy.

Bridle Snubber

แปลว่า(english) The roll above the bridle rolls used to thread the strip. Also is used to steer the strip through the bridle.

Brass

แปลว่า(english) An alloy that is 70% copper,30% zinc. One of the most widely used of the copper-zinc alloys; malleable and ductile; excellent cold-working but poor hot-working and machining properties; excellent for soft-soldering; good for silver alloy brazing or oxyacetylene welding, but fair for resistance or carbon-arc welding. Used for drawn cartridges, tubes, eyelets machine items and snap fasteners.