ผลการค้นหา

ค้นเจอ 610 รายการ

Base Metal

(english) (1) The metal present in the largest proportion in an alloy; (2) the metal to be brazed, cut or welded; (3) after welding the part of the metal that was not melted during the process.

Scheduling

(Software Engineering) the activity that lays out a timeline for work to be conducted on a project

System engineering

(Software Engineering) focuses on the analysis and design of all elements of a complete product, service, or technology for the transformation of information or control

Transmissibility:

(english) The principle stating that a force has the same external effect on an object regardless of where it acts along its line of action.

Paradigms

(Software Engineering) the process model

Z-Mill

(english) The full name for z-mill is Sendzimir mill. A Z-mill operates with a very small diameter work roll, normally about 2 inches, backed up by a number of rolls in a pyramid-shaped stack. This roll set up allows you to exert extremely high forces through the work roll and yet keep the work roll from extreme flexing. The take-up roll on the Z-Mill also exerts a tension on the coil as it comes through the mill. The combination of high pressure and tension makes the mill capable of rolling material thin and flat.

Tests on Completion

การทดสอบเมื่อเสร็จงาน

Burr

(english) The very subtle ridge on the edge of strip steel left by cutting operations such as slitting, trimming, shearing, or blanking. For example, as a steel processor trims the sides of the sheet steel parallel or cuts a sheet of steel into strips, its edges will bend with the direction of the cut.

Bedding

(english) Sinking a pattern down into the sand to the desired position and ramming the sand around it.

Breakout

(english) An accident caused by the failure of the walls of the hearth of the furnace resulting in liquid iron or slag (or both) flowing uncontrolled out of the blast furnace.

Holding Period Period

(Concrete Engineering) In the manufacture of concrete products, the period between completion of casting and the introduction of additional heat or the steam curing period

Equilibrium:

(english) An object is in equilibrium if the resultant of the system of forces acting on it has zero magnitude. See static equilibrium and dynamic equilibrium.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด