ตัวกรองผลการค้นหา
คลิกที่แต่ละคำเพื่อดูรายละเอียด
มีได้รับการขยายเวลา
(english) An early step in preparing flat-rolled steel for use by an end user. A blank is a section of sheet that has the same outer dimensions as a specified part (such as a car door or hood) but that has not yet been stamped. Steel processors may offer blanking for their customers to reduce their labor and transportation costs; excess steel can be trimmed prior to shipment.
(Software Engineering) an indication of the overall effort to be expended or the number of people working on the project
(Software Engineering) the person or group that has requested the software and will be paying the bill for its development
(english) Market condition where the spot, or current price for a metal is higher than the three-month delivery price. This usually indicates immediate demand is perceived to be stronger than long-term demand. Not considered to be a "normal" market state (See Contango).
(Environmental Engineering) Treatment of a waste in place, as opposed to pumping or digging the waste up and then treating it.
An informal measure of the ease with which a user interface can be learned and applied with efficiency and without errors
(english) The mineral zircon silicate, ZrSiO4, a very high melting point acid refractory material used as a molding material in steel foundries.
(Software Engineering) any cohesive and persistent information that is produced as a consequence of one or more software engineering actions of tasks
(Concrete Engineering) A device for determining the consistency of fresh concrete. It is sometimes used as an alternative to the slump test.
(Concrete Engineering) A tool having a serrated face, as rows of pyramidal points, used to develop an architectural finish for concrete surfaces.
(english) Any vector can be expressed as a collection of vectors whose sum is equal to the original vector. Each vector in this collection is a component of the original vector. It is common to express a vector in terms of components which are parallel to the x and y axes.