ผลการค้นหา

ค้นเจอ 117 รายการ

Bearing Load

(english) A compressive load supported by a member, usually a tube or collar, along a line where contact is made with a pin, rivet, axle, or shaft.

A Sheet Metal Screw

(english) Sheet metal screws with (a) sharp-pointed ends; and (b) fewer threads per inch than type AB screws; and (c) deeper threads with bettere gripping power than type AB. The industrial Fasteners Institue incorrectly labes type A an “obsolete” thread though it is universally preferred in 18-8 stainless over type AB, especially by the marine industry.

Task analysis

(Software Engineering) a software engineering action that is conducted as part of user interface design; intended to better understand how a user is to interact with a system

Basic Steel

(english) Steel melted in a furnace with a basic bottom and lining and under a slag containing an excess of a basic substance such as magnesia or lime.

Accordion Reed Steel

(english) Hardened, tempered, polished and blued or yellow flat steel with dressed edges. Carbon content about 1.00. Material has to possess good flatness, uniform hardness and high elasticity.

Baller Stick

(english) Octagon-shaped wooden stick approximately 5' long. This stick is used in the baller area, to change burr mashers, to start a coil with a large ID, etc.

Debugging

(Software Engineering) the activity associated with finding and correcting an error or defect - a lack of conformance to requirements found in the software after delivery to the customer

BACK-UP RING

(english) A fabric or plastic device that is used with an o-ring or other gasket to prevent extrusion of the o-ring or gasket into an adjacent space or crevice

Bentonite

(english) A colloidal clay derived from volcanic ash and employed as a binder in connection with synthetic sands, or added to ordinary natural (clay-bonded) sands where extra strength is required.

ADAPTER

(english) A mechanical device used to align the shaft of an electric motor (or other rotary device) with the shaft of a hydraulic pump to maintain radial and parallel shaft alignment.

Sacking

(Concrete Engineering) Removing or alleviating defects on a concrete surface by applying a mixture of sand and cement to the moistened surface and rubbing with a coarse material such as burlap.

Reactive waste

(Environmental Engineering) A waste which; 1) reacts violently with water, 2) forms potentially explosive mixtures with water, 3) is normally unstable, 4) contains cyanide or sulfide in sufficient quantity to evolve toxic fumes at high or low pH, 5) is capable of exploding if heated under pressure, or 6) is an explosive compound listed in Department of Transportation (DoT) regulations. One of EPA's four hazardous waste properties.

ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z

ดูหมวดหมู่ทั้งหมด