ค้นเจอ 585 รายการ

คำศัพท์ช่างภาษาอังกฤษ - ไทยที่เกี่ยวข้องกับ "open the mouth"

คลิกที่แต่ละคำเพื่อดูรายละเอียด

Vapor Pressure

(Concrete Engineering) The pressure exerted by a vapor that is calculated based upon relative humidity and temperature. The higher the humidity and higher temperature, in degrees Fahrenheit, the greater the vapor pressure exerted.

Linear:

(english) A structure is said to behave linearly when its the deformation response is directly proportional to the loading (i.e. doubling the load doubles the displacement response). For a material, linear means that the stress is directly proportional to the strain.

Troposphere

(Environmental Engineering) The lower atmosphere, from the earth's surface to approximately 12 km. This portion of the earth's atmosphere contains about 95 percent of the atmospheric gases. The temperature gradually declines through this region.

Project size

(Software Engineering) an indication of the overall effort to be expended or the number of people working on the project

Customer

(Software Engineering) the person or group that has requested the software and will be paying the bill for its development

Organic compound

(Environmental Engineering) Any compound containing carbon except for the carbonates (carbon dioxide, the carbonates and bicarbonates), the cyanides, and cyanates.

Bauxite

(english) The only commercial ore of aluminum, corresponding essentially to the formula Al2O3xH2O.

Measurement

(Software Engineering) collecting quantitative data about the software or the software engineering processMetrics

Architectural design

an activity that attempts to layout the module "floor plan" for the software

Blow

(english) The impact or force delivered by one workstroke of the forging equipment.

Bending Angle

(english) A 'V-shaped' piece of angle iron attached to the rear of the coil car in the Strip Steel, which is used to help the operator put bends into the front end of a coil.

spotting the center

(เครื่องจักร) การเจาะจุดศูนย์กลาง คือ การเจาะศูนย์กลาง คือ การเจาะศูนย์ด้วยเครื่องมือปลายแหลมทำเป็นจุดนำไว้ สำหรับเจาะด้วยเครื่องมือใหญ่ตอ่ไป


 ศัพท์ช่างภาษาอังกฤษ – ไทย จัดกลุ่มตามตัวอักษร A-Z