ผลการค้นหา

Effluent based standards

แปลว่า(Environmental Engineering) Standards which set concentration or mass per time limits on the effluent being discharged to a receiving water.

Bazooka

แปลว่า(english) Performs functions of Galvanneal Furnace; set of torches on wheels used to shoot flames onto a strip to further heat it.

Software process improvement (SPI)

แปลว่า(Software Engineering) a set of software engineering activities that attempt to improve the state of software engineering practice within an organization

Quality management

แปลว่า(Software Engineering) a set of software engineering actions that helps ensure that software is built in a way that achieves high quality

Keene's Cement

แปลว่า(Concrete Engineering) A finely ground high density plaster composed of anhydrous, (calcined or "dead burned") gypsum, the set of which is accelerated by the addition of other materials.

BOLT KIT

แปลว่า(english) A set of bolts or screws that ore selected to suit a particular application, i.e. pre-selected length, threads and strength to match the mounted component.

Blast Cleaning (blasting)

แปลว่า(english) A process for cleaning or finishing metal objects by use of an air jet or centrifugal wheel that propels abrasive particles (grit, sand, or shot) against the surfaces of the workpiece at high velocity.

Blow Back

แปลว่า(english) A coating defect consisting of a lower coating film weight on the bottom of the coated sheet caused by high velocity air in the oven. Blow back usually occurs with high solids coatings which have little solvent to evaporate and "set" the film.

Z-Mill

แปลว่า(english) The full name for z-mill is Sendzimir mill. A Z-mill operates with a very small diameter work roll, normally about 2 inches, backed up by a number of rolls in a pyramid-shaped stack. This roll set up allows you to exert extremely high forces through the work roll and yet keep the work roll from extreme flexing. The take-up roll on the Z-Mill also exerts a tension on the coil as it comes through the mill. The combination of high pressure and tension makes the mill capable of rolling material thin and flat.