ผลการค้นหา

drive shaft joint

แปลว่าหัวอัดจารบีเพลาขับ

vertical bowl face gasker

แปลว่าแหวนอัดด้านหน้าตรงของกระเปาะน้ำมันคาบูเรเตอร์

rear axle shaft flange

แปลว่าดุมเพลาท้าย, จานครอบเพลาท้าย

bearing between axle shaft and casing

แปลว่าแบริ่งระหว่างเพลากับเรือนหุ้มเพลา

bearing between hub and axle shaft

แปลว่าแบริ่งระหว่างดุมครอบเรือนเพลากับเพลา

ADAPTER

แปลว่า(english) A mechanical device used to align the shaft of an electric motor (or other rotary device) with the shaft of a hydraulic pump to maintain radial and parallel shaft alignment.

Blast Furnace 2

แปลว่า(english) A vertical shaft type smelting furnace in which an air blast is used, usually hot, for producing pih iron. The furnace is continuous in operation using iron ore, coke, and limestone as raw materials which are charged at the top while the molten iron and slag are collected at the bottom and are tapped out at intervals.

Bearing Load

แปลว่า(english) A compressive load supported by a member, usually a tube or collar, along a line where contact is made with a pin, rivet, axle, or shaft.

Bent Axis Pumps

แปลว่า(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump.

Potential Energy:

แปลว่า(english) The energy stored in a raised object (e.g. the weights in a grandfather clock). Potential energy equals mgh, where m is mass, g is the acceleration of gravity, and h is the vertical distance from a reference location. It is called potential energy because the energy can be regained when the object is lowered. This type of potential energy is sometimes called gravitational potential energy in order to distinguish it from elastic potential energy: see elastic energy.