ผลการค้นหา

Scheduling

แปลว่า(Software Engineering) the activity that lays out a timeline for work to be conducted on a project

Bright Annealing

แปลว่า(english) A process carried out usually in a controlled furnace atmosphere, so surface does not oxidize, remaining bright.

BREATHER

แปลว่า(english) A device which permits air to move in and out of a container or component to maintain atmospheric pressure.

Ball Piston Pumps

แปลว่า(english) The Ball Piston Pump is a very simple pump design. It has a rotor which revolves around an internal stator. The rotor has twelve cylinders machined out of it, and each cylinder has a ball inside which can slide in and out of the cylinder.

Broaching

แปลว่า(english) Smoothing machined holes or outside surfaces of castings by drawing pushing on or more broaches (special cutting tools) through the roughed out hole.

Concentrated force:

แปลว่า(english) A force considered to act along a single line in space. Concentrated forces are useful mathematical idealizations, but cannot be found in the real world, where all forces are either body forces acting over a volume or surface forces acting over an area.

Bleeder

แปลว่า(english) A defect wherein a casting lacks completeness due to moltn metal draining or leaking out of some part of the mold cavity after pouraing has stopped.

Breakout

แปลว่า(english) An accident caused by the failure of the walls of the hearth of the furnace resulting in liquid iron or slag (or both) flowing uncontrolled out of the blast furnace.

Blast Furnace 2

แปลว่า(english) A vertical shaft type smelting furnace in which an air blast is used, usually hot, for producing pih iron. The furnace is continuous in operation using iron ore, coke, and limestone as raw materials which are charged at the top while the molten iron and slag are collected at the bottom and are tapped out at intervals.

Black Plate

แปลว่า(english) A light weight or a thin uncoated steel sheet or strip so called because of its dark oxide coloring prior to pickling. It is manufactured by two different processes. (1) Form sheet bar on single stand sheet mills or sheet mills in tandem. This method is now almost obsolete. (2) On modern, high speed continuous tandem cold reduction mills from coiled hot rolled pickled wide strip into ribbon wound coils to finished gage. Sizes range from 12 to 32 in width, and in thicknesses from 55 lbs. to 275 lbs. base box weight. It is used either as is for stampings, or may be enameled or painted or tin or terne coated.