ผลการค้นหา

Burr Mashers

แปลว่า(english) Devices used to remove build up on edge of strip after the slitting process.

Block Off

แปลว่า(english) 1) Wooden separators which are used at both the bottom of a lift and between IPM's (bundles) of a lift. 2) The act of placing 4x4s between the lifts in the piler's box.

Slump Cone

แปลว่า(Concrete Engineering) A metal mold in the form of a truncated cone with a top diameter of 4”, a bottom diameter of 8”, and a height of 12”, used to fabricate the specimen for a slump test.

Clarifier (sedimentation basin)

แปลว่า(Environmental Engineering) A tank in which quiescent settling occurs, allowing solid particles suspended in the water to agglomerate and settle to the bottom of the tank. The solids resulting from the settling being removed as a sludge.

Back-up Roll

แปลว่า(english) 1) Roll used as a support roll mainly for plater rolls. 2) Two rolls, one on top and one on bottom of the two work rolls which apply pressure and reduce the flexing of the work rolls.

Zirconia

แปลว่า(english) ZrO2 an acid refractory up to 2500 B0C (4532 B0F) having good thermal shock resistance and low electrical resistively.

In situ treatment

แปลว่า(Environmental Engineering) Treatment of a waste in place, as opposed to pumping or digging the waste up and then treating it.

Burnt Rubber

แปลว่า(english) Small or large black spots that generally show up on surface and are generally caused by pickling steel too hot.

Blow Back

แปลว่า(english) A coating defect consisting of a lower coating film weight on the bottom of the coated sheet caused by high velocity air in the oven. Blow back usually occurs with high solids coatings which have little solvent to evaporate and "set" the film.

Bust Coil

แปลว่า(english) Coils removed from the off-gauge reel. The BUST (build up side trimmer) coil contains defects (gauge variation and quality defects) and off-spec widths.

Cement Gel

แปลว่า(Concrete Engineering) The colloidal gel (glue like) material that makes up the major portion of the porous mass of which hydrated cement paste is composed.

Slip Form

แปลว่า(Concrete Engineering) A form which is raised or pulled as concrete is placed; may move vertically to form wails, stacks, bins or silos, usually of uniform cross section from bottom to top; or a generally horizontal direction to lay concrete evenly for highways, on slopes and inverts of canals, tunnels, and siphons.